Specifications - Makita 6842 Bedienungsanleitung

ENGLISH (Original instructions)
1-1. Lock button
1-2. Switch trigger
2-1. Reversing switch lever
3-1. Hook
3-2. Clamping screw
4-1. Casing
4-2. Thumb screw
5-1. Plane bearing
5-2. Dust cover
5-3. Bit

SPECIFICATIONS

Model
Screw strip
No load speed (min
Overall length
Net weight
Safety class
• Due to our continuing programme of research and development, the specifications herein are subject to change without notice.
• Specifications may differ from country to country.
• Weight according to EPTA-Procedure 01/2003
Intended use
The tool is intended for screw driving in wood, metal and
plastic.
Power supply
The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and can
only be operated on single-phase AC supply. They are
double-insulated in accordance with European Standard
and can, therefore, also be used from sockets without
earth wire.
Noise
The typical A-weighted noise level determined according
to EN60745:
Model 6842, 6843
Sound pressure level (L
Sound power level (L
Uncertainty (K) : 3 dB(A)
Model 6844
Sound pressure level (L
Sound power level (L
Uncertainty (K) : 3 dB(A)
Wear ear protection
Explanation of general view
6-1. Lever
6-2. Stopper base
6-3. Label on feeder box
6-4. Fenestella
7-1. Stopper base
7-2. Casing
7-3. Adjusting knob
8-1. Feeder box
8-2. Screw strip
8-3. Screw guide
-1
)
ENE033-1
ENF002-1
ENG905-1
) : 84 dB(A)
pA
) : 95 dB(A)
WA
) : 85 dB(A)
pA
) : 96 dB(A)
WA
6842 6843
4 mm x 25 mm - 55 mm
4,700 6,000
400 mm
2.0 kg
Vibration
The vibration total value (tri-axial vector sum) determined
according to EN60745:
Work mode: screwdriving without impact
Vibration emission (a
Uncertainty (K) : 1.5 m/s
The declared vibration emission value has been
•
measured in accordance with the standard test
method and may be used for comparing one tool
with another.
The declared vibration emission value may also be
•
used in a preliminary assessment of exposure.
WARNING:
The vibration emission during actual use of the
•
power tool can differ from the declared emission
value depending on the ways in which the tool is
used.
Be sure to identify safety measures to protect the
•
operator that are based on an estimation of
exposure in the actual conditions of use (taking
account of all parts of the operating cycle such as
the times when the tool is switched off and when it
is running idle in addition to the trigger time).
4
9-1. Driving position
11-1. Reverse button
13-1. Extension handle
15-1. Wall
15-2. Stopper base
16-1. Limit mark
17-1. Brush holder cap
17-2. Screwdriver
6846
4 mm x 45 mm - 75 mm
3,000
/II
2
) : 2.5 m/s or less
h
2
6844
440 mm
2.1 kg
ENG900-1
ENG901-1