Specifications - Makita DFT043F Betriebsanleitung

ENGLISH (Original instructions)
1. Red part
2. Button
3. Battery cartridge
4. Switch trigger
5. Reversing switch lever
6. Front lamp
7. LED indicator

SPECIFICATIONS

Fastening torque
No load speed (min
Dimensions (L x W x H)
Rated voltage
• Due to our continuing program of research and development, the specifications herein are subject to change without
notice.
• Specifications and battery cartridge may differ from country to country.
• Weight, with battery cartridge, according to EPTA-Procedure 01/2003
Intended use
The tool is intended for screw driving in wood, metal and
plastic.
General Power Tool Safety
Warnings
WARNING Read all safety warnings and all
instructions. Failure to follow the warnings and
instructions may result in electric shock, fire and/or
serious injury.
Save all warnings and
instructions for future reference.
CORDLESS SCREWDRIVER
SAFETY WARNINGS
1. Hold power tool by insulated gripping surfaces,
when performing an operation where the fastener
may contact hidden wiring. Fasteners contacting a
"live" wire may make exposed metal parts of the
power tool "live" and could give the operator an
electric shock.
2. Always be sure you have a firm footing.
Be sure no one is below when using the tool in
high locations.
3. Hold the tool firmly.
4. Keep hands away from rotating parts.
5. Do not touch the bit or the workpiece immediately
after operation; they may be extremely hot and
could burn your skin.
4
Explanation of general view
8. Adjust grip
9. Ring
10. Adjust ring
11. Scale
12. Hole for adjust grip
13. Yellow line
14. Compression spring
Model
Hard joint
Soft joint
-1
)
Net weight
DFT043F
1 - 4 N•m
1 - 4 N•m
80
SAVE THESE INSTRUCTIONS.
ENE033-1
WARNING:
DO NOT let comfort or familiarity with product (gained
from repeated use) replace strict adherence to safety
rules for the subject product. MISUSE or failure to
GEA010-1
follow the safety rules stated in this instruction
manual may cause serious personal injury.
IMPORTANT SAFETY
INSTRUCTIONS
FOR BATTERY CARTRIDGE
1. Before using battery cartridge, read all
instructions and cautionary markings on (1)
battery charger, (2) battery, and (3) product using
GEB050-2
battery.
2. Do not disassemble battery cartridge.
3. If operating time has become excessively shorter,
stop operating immediately. It may result in a risk
of overheating, possible burns and even an
explosion.
4. If electrolyte gets into your eyes, rinse them out
with clear water and seek medical attention right
away. It may result in loss of your eyesight.
5. Do not short the battery cartridge:
(1)
(2)
(3)
15. Bit
16. Sleeve
17. Bit-piece
18. Limit mark
19. Brush holder cap
20. Screwdriver
DFT083F
3 - 8 N•m
3 - 8 N•m
80
200 mm x 72 mm x 255 mm
1.5 kg
D.C. 14.4 V
Do not touch the terminals with any
conductive material.
Avoid storing battery cartridge in a container
with other metal objects such as nails, coins,
etc.
Do not expose battery cartridge to water or
rain.
DFT125F
5 - 12 N•m
5 - 12 N•m
150
ENC007-6