Specifications - Makita DFL123F Betriebsanleitung

ENGLISH
(Original instructions)
1 Red indicator
2 Button
3 Battery cartridge
4 Indicator lamps
5 Check button
6 Switch trigger
7 Reversing switch lever
8 Lamp
9 Angle head

SPECIFICATIONS

Fastening torque
Square drive
No load speed (min
Overall length
(Depending on the battery)
Net weight
Rated voltage
• Due to our continuing program of research and development, the specifications herein are subject to change without
notice.
• Specifications may differ from country to country.
• The weight may differ depending on the attachment(s), including the battery cartridge. The lightest and heaviest combi-
nation, according to EPTA-Procedure 01/2014, are shown in the table.
Applicable battery cartridge and charger
Battery cartridge
Charger
• Some of the battery cartridges and chargers listed above may not be available depending on your region of resi-
dence.
WARNING: Only use the battery cartridges and chargers listed above. Use of any other battery cartridges
and chargers may cause injury and/or fire.
Intended use
The tool is intended for screw driving in wood, metal and
plastic.
General Power Tool Safety Warnings
WARNING Read all safety warnings, instructions,
illustrations and specifications provided with this
power tool. Failure to follow all instructions listed below
may result in electric shock, fire and/or serious injury.
Save all warnings and instructions for future
reference.
The term "power tool" in the warnings refers to your
mains-operated (corded) power tool or battery-operated
(cordless) power tool.
4
Explanation of general view
10 Adjust ring
11 Ring
12 Scale
13 Adjust grip
14 Hole for adjust grip
15 Yellow line
16 Compression spring
17 Socket
18 Hole
Model
Hard joint
Soft joint
–1
)
BL1415N / BL1415NA / BL1430 / BL1430B / BL1440 / BL1450 / BL1460A / BL1460B
DC18RC / DC18RD / DC18RE / DC18SD / DC18SE / DC18SF
ENE033-1
CORDLESS SCREWDRIVER SAFETY
WARNINGS
1. Hold the power tool by insulated gripping sur-
GEA010-2
faces, when performing an operation where the
fastener may contact hidden wiring. Fasteners
contacting a "live" wire may make exposed metal
parts of the power tool "live" and could give the oper-
ator an electric shock.
2. Always be sure you have a firm footing.
Be sure no one is below when using the tool in
high locations.
3. Hold the tool firmly.
4. Keep hands away from rotating parts.
5. Do not touch the bit or the workpiece immedi-
ately after operation; they may be extremely hot
and could burn your skin.
6. Always secure workpiece in a vise or similar
hold-down device.
SAVE THESE INSTRUCTIONS.
19 Pin
20 With battery cartridge BL1415N,
BL1415NA
21 Range of fastening capacity
22 Revolution angle (°)
23 Torque
24 With battery cartridge BL1430,
BL1430B, BL1440, BL1450,
BL1460A, BL1460B
DFL123F
5 – 12 N·m
5 – 12 N·m
9.5 mm
1,200
417 – 429 mm
1.5 – 2.1 kg
D.C. 14.4 V
GEB139-1