Spares; Safety Guard Parts - Hartridge HB378 Bedienungs- Und Wartungshandbuch

OPERATING & SERVICING MANUAL

6. Spares

6.1 Safety Guard Parts

Item Description
1 Guard Door R/H
2 Guard Door L/H
3 Reinforcing plate
4 Guard Frame
5 Guard Outer End Panel
6 Guard Inner End Panel
7 Guard Switch Loom
8 Pressure Dump Valve Assembly
9 Air solenoid valve
10 Air pressure regulator
NOTE 1 Guard Height Changes
The first 10 guards produced were 470mm high (see dimension 'A' in Figure 6.1). Subsequent
guards are 550mm high. For correct spares ordering, measure dimension 'A' on your guard and
order as follows:
For 470mm high guards, order part numbers A069B2xx.
For 550mm high guards, order part numbers A069B3xx.
NOTE 2 The reinforcing plates must always be present during operation.
NOTE 3 The dump valve assembly is factory set. In the event of malfunction contact Hartridge™
to obtain a replacement.
24
THIS IS AN UNCONTROLLED DOCUMENT downloaded by Lukas Matuska on 16 Feb 2016
Any technical intervention requires certified Hartridge training. Contact Hartridge Ltd for details.
Figure 6.1: Safety Guard Spares
(metering unit end)
(AVM2 bulkhead end)
HARTRIDGE LIMITED
Part Number
A069B200 or A069B300 (see Note 1)
A069B201 or A069B301 (see Note 1)
A069B305 2 off (see Note 2)
A069B202 or A069B302 (see Note 1)
A069B203 or A069B303 (see Note 1)
A069B204 or A069B304 (see Note 1)
A069B813
A069B002 (see Note 3)
8941095
Part of A069B002 (see Note 3)
HL024, Issue 7 (AT2672)