Danger Of Explosion; Before Use; Charging; Assembly - Silvercrest SRBX 2200 B1 Bedienungs- Und Sicherheitshinweise

DANGER OF
EXPLOSION!
Do not throw the product into
¾
fire .
˜ Before use
NOTES:
Remove all packaging materials .
¾
Check if all parts are complete .
¾
Before first use: Charge the built-in battery for
¾
at least 90 minutes .
˜ Charging
m
ATTENTION! Before charging, switch off the
product .
NOTES:
While charging, the product cannot be
¾
switched on .
Only recharge the battery when the power of
¾
the product becomes noticeably weaker .
Open the lid 8 at the bottom .
¾
Connect the cable of the power adaptor 10
¾
to the charging socket 9 .
Connect the power adaptor 10 to a suitable
¾
socket outlet .
The charging LED 7 shows the status:
¾
Status

Charging

Fully charged
LED
Flashing
Static
When fully charged: Disconnect the power
¾
adaptor 10 from the charging socket 9 and
from the socket outlet .
Close the lid 8 .
¾
NOTES:
Charging time: 4 to 5 hours .
¾
When fully charged: The product
¾
automatically switches to a trickle charge
(maintenance function) .
To avoid possible a damage to the battery, do
¾
not leave the product permanently connected
to the socket outlet .
˜ Assembly
˜ Extension handle
Mounting the extension handle 1 :
¾
Push the extension handle 1 on the product
until the release button 2 locks into place
(see fig . B) .
Dismounting the extension handle 1 :
¾
Push and hold the release button 2 . Pull the
extension handle from the product (see fig . B) .
Extending the extension handle 1 :
¾
Turn the handle grip 3 slightly in an
anti-clockwise direction . Adjust the length .
Fasten it by turning it in a clockwise direction
(see fig . C) .
˜ Brush heads
(see fig . D)
Switch off the product .
¾
GB/IE 21