Cleaning And Maintenance Of The Appliance; Anti-Scaling System - Fakir GALAXIS Benutzerhandbuch

EN
Self-Cleaning
Ensure that you have unplugged the appliance, fill the water reservoir up to MAX position
after ensuring that the steam selector is at "O" position. Do not add vinegar or similar
materials in the water reservoir. Set the maximum ironing temperature. Plug the appliance,
and remove the plug when the power indication lamp of the iron turns off. Bring the iron
above the sink. Bring the steam control button to self-cleaning position and wait until boiling
hot water, steam and dirt comes out of the soleplate. Release the steam control button
when all water in the reservoir is used. If dirt remains on the iron after this procedure,
repeat the self-cleaning procedure. After the self-cleaning process, plug the appliance and
heat the iron so that the soleplate dries. Unplug the appliance when the specified ironing
temperature is reached. Clean the water stains that occur on the soleplate by moving the
hot iron on a used cloth. Leave the iron until it is cooled before storing.
Bring the temperature adjustment knob to minimum position.
Unplug the appliance from the outlet. Lay the iron on its back to the
upright position.
Before cleaning the steam iron, the plug must be unplugged
and it must fully cooled. Do not use corrosive
cleaning agents.
A special resin filter inside the water reservoir
softens the water and prevents scaling on the plate. There is no need to
replace the resin filter.
When You Are Done With Ironing
Bring the temperature adjustment knob to minimum position. Unplug the appliance from the
outlet. Lay the iron on its back to the upright position.

Cleaning and Maintenance of the Appliance

Before cleaning the steam iron, the plug must be unplugged and it must fully cooled. Do not
use corrosive cleaning agents.

Anti-Scaling System

A special resin filter inside the water reservoir softens the water and prevents scaling on the
plate. There is no need to replace the resin filter.
NOTE!
Use only tap water. Filtered and demineralized water causes "Zero Scale" , anti-scaling
system shall fail when the physical and chemical properties of the water are changed.
Do not use chemical additives, odourous materials or descaling agents. Warranty shall
be void when the instructions provided above are not followed.
28