Herunterladen Inhalt Inhalt Diese Seite drucken

SUHNER ROTOmax 3.5 Originalbetriebsanleitung Seite 24

Vorschau ausblenden Andere Handbücher für ROTOmax 3.5:
Inhaltsverzeichnis

Werbung

4) Drehzahl Bestätigung «enter»
5) Startbefehl «run»
6) Stopbefehl «stop»
7) EIN/AUS Sicherheitsvorrichtung
«step»
3.1.2 Start der Maschine
• Schlüssel und Einstellwerk-
zeuge vor dem Einschalten
entfernen.
• Biegsame Welle beim Ein-
schalten gestreckt halten.
• Während des Betriebes und
bei der Lagerung auf grosse
Krümmungsradien der Bieg-
samen Welle achten.
Vor dem Start der Maschine Hand-
stück festhalten!
• Maschinen Hauptschalter
betätigen
• Drehzahlanzeige blinkt.
• Mit Tasten «-/+» Drehzahl
vorwählen
• Drehzahlanzeige blinkt, bis
Vorwahl mit Taste «enter»
bestätigt wird
• Drehzahl ist gespeichert
24
DE
« -/+ »
4) Confirmation du régime de rota-
tion « enter »
5) Commande de démarrage « run »
6) Commande d'arrêt « stop »
7) EN/HORS Dispositif de sécurité
« step »
3.1.2 Démarrage de la ma-
chine
• Eloigner les clés de l'outillage
de réglage avant l'enclenche-
ment.
• Maintenir l'arbre flexible tendu
lors de l'enclenchement.
• Durant le travail et lors de
l'entreposage veiller à obser-
ver de grands rayons de
courbure de l'arbre flexible.
Avant le démarrage de la machine
maintenir fermement la partie
manuelle !
• Actionner l'interrupteur princi-
pal de la machine
• L'affichage du régime de rota-
tion clignote.
• A l'aide des touches « -/+ »
présélectionner le régime de
rotation
• L'affichage du régime de
rotation clignote jusqu'à la
confirmation avec la touche «
FR
4) Speed confirmation «enter»
5) «run» start command
6) «stop» start command
7) ON/OFF «step» safety device
3.1.2 Starting the machine
• Before turning on the ma-
chine, make sure to remove
wrenches and adjusting
tools.
• When turning on, hold the
flexible shaft extended.
• During operation and stor-
age, make sure that the flex-
ible shafts have large bend
radii.
Before starting the machine, hold the
hand tool against turning!
• Operate power switch of the
machine
• Speed gauge blinking.
• Pre-select speed with key
«-/+»
• The speed gauge blinks until
the pre-selection is confirmed
with the «enter» key
• The speed is saved
GB

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis