Closing The Front Fascia; Sensor Resistance Values; Fe 7 Remote Control; Fet Remote Control - STIEBEL ELTRON WPM Bedienungsanleitung

INsTALLATIoN

Closing the front fascia

5.3.3 Sensor resistance values

Temperature in °C
- 30
- 20
-10
0
10
20
25
30
40
50
60
70
80
90
100
110
120
5.4

FE 7 remote control

Note
If you are connecting an FE 7 remote control, you cannot
use an FET remote control.
FE 7 connection array
With the FE 7 remote control you can adjust the set room temper-
ature for heating circuit 1 by ± 5 °C. This function is enabled only
in PROGRAMMED OPERATION. You can also change the operating
mode.
f Connect the remote control to terminal X1.13. f
5.5

FET remote control

Note
If you are connecting one or multiple FET remote controls,
you cannot use an FE 7 remote control.
www.stiebel-eltron.com
FET connection array
PT 1000 sensor
Resistance in Ω
882
922
961
1000
1039
1078
1097
1117
1155
The FET digital remote control enables convenient operation of
1194
one heating zone.
1232
f Attach the remote control to one of the CAN B terminals. f
1271
f Observe the FET operating instructions. f
1309
1347
1385
5.6

Internet Service Gateway ISG

1423
The Internet Service Gateway ISG enables you to operate the heat
1461
pump in your local home network and via the internet whilst you
are away from home.
f Attach the Internet Service Gateway to one of the CAN B ter- f
minals (not one marked "+").
f Observe the ISG operating instructions. f
The ISG is not supplied with power by the heat pump.
6. Closing the front fascia
1 CAN bus for programming unit
f Connect the connecting lead from the programming unit to f
one of the "CAN bus for programming unit" connections.
f Attach the front fascia at the top of the device. f
f Press in the bottom of the front fascia firmly. f
f Secure the fascia at the bottom with the screw. f
+ - L
6
H
1
1
WPM | 19