Mounting The Handle - Makita DBC260U Originalbetriebsanleitung

Mounting the handle

CAUTION: Before doing any work on the brush cutter, always stop the engine
and disconnect the spark plug connector from the spark plug.
Always wear protective gloves!
CAUTION: Ensure you have reassembled the brush cutter completely before
starting it.
For U Handle models
– Place the handle-fixing metal so that the handle with the control lever is
positioned on the right (the right-hand grip side) when viewed from the engine
side.
– Fit the groove of the handle-fixing material to the handle end. Temporarily fix
the attached metal using the hexagon socket bolt provided.
– Adjust the handle to an easy-to-operate position, and securely tighten the
four hexagon socket bolts uniformly on the right and left using an Allen key.
– Fit the control cable (together with the earth cord) to the handle with two clips
(1).
– Make sure the control cable does not loop at the handle bar section.
For Loop Handle models
– Fix a barrier to the left side of the machine together with the handle for
operator protection.
– Make sure that the grip/barrier assembly is fitted between the spacer and the
arrow mark.
WARNING: Do not remove or shrink the spacer. The spacer keeps a certain
distance between both hands. Setting the grip/barrier assembly
close to the other grip beyond the length of the spacer may cause
loss of control and serious personal injury.
(1)
to Engine
10
DBC260U
DBC260U
Arrow mark
DBC260L