Herunterladen Inhalt Inhalt Diese Seite drucken

Cleaning The Air Filter; Gear; Cleaning And Lubrication - Husqvarna 525HF3S Bedienungsanweisung

Vorschau ausblenden Andere Handbücher für 525HF3S:
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 222
Cleaning the air filter
Close the choke control by setting the choke into a choke
position.
Remove the air filter cover and take out the filter. Wash it
clean in warm, soapy water. Ensure that the filter is dry
before refitting it.
An air filter that has been in use for a long time cannot be
cleaned completely. The filter must therefore be replaced
with a new one at regular intervals. A damaged air filter
must always be replaced.
If the machine is used in dusty conditions the air filter
should be soaked in oil. See instructions under the
heading Oiling the air filter.
Oiling the air filter
Always use HUSQVARNA filter oil, art. no. 531 00 92-48.
The filter oil contains a solvent to make it spread evenly
through the filter. You should therefore avoid skin contact.
Put the filter in a plastic bag and pour the filter oil over it.
Knead the plastic bag to distribute the oil. Squeeze the
excess oil out of the filter inside the plastic bag and pour
off the excess before fitting the filter to the machine. Never
use common engine oil. This would drain through the filter
quite quickly and collect in the bottom.
20 – English
MAINTENANCE

Gear

There is a grease nipple for filling lubricant on the gear
housing. Use a grease gun to fill with grease. This should
be done after every 60 working hours. Use Husqvarna's
gear grease - hedge trimmer.
CAUTION! The gear housing must not be filled
completely with grease. The grease expands as the
machine heats up during operation. If the gear housing
was completely filled with grease it could damage the
seals and lead to leakage of grease.
The grease in the gear house does not normally need to
be changed except if repairs are carried out.

Cleaning and lubrication

Clean any resin and plant residue from the blades using
Husqvarna cleaning agent (UL22) before and after using
the machine.
Lubricate the blade bars with husqvarnas special grease,
part no. (UL 21) before long periods of storage.
1157493-38 Rev. 1 2015-01-26

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis