Safety Instructions - Klarstein Tap2Go Handbuch

EN
12

SAFETY INSTRUCTIONS

• Check that the power cord is undamaged before use. If the power cord or plug is
damaged, it must be replaced by the manufacturer, an authorized service center,
or a similarly qualified person.
• Before use, check the voltage on the device label. Connect the equipment only to
an outlet that is suitable for the voltage of the equipment.
• Do not touch the power plug with wet hands.
• Place the beer cooler on a dry and horizontal surface.
• To ensure good ventilation of the beer cooler, leave at least 10 cm space around
the beer cooler on both sides to ensure adequate ventilation of the appliance.
• Never place the beer cooler in direct sunlight.
• Never cover the beer cooler.
• The beer cooler must be installed in an area that is protected from weather
conditions such as wind, rain, splashing water or drops of water.
• Before cleaning or servicing the beer cooler, make sure that the plug has been
removed from the socket.
• Do not immerse the beer cooler or power plug in water or any other liquid.
• Do not use scouring pads or abrasive cleaners to clean the beer cooler.
• Do not remove the keg from the beer cooler until it has been completely emptied.
• Never let children climb on the beer cooler and make sure that children do not play
with the beer cooler.