General Safety Instructions - CONDTROL Laser 3D Bedienungsanleitung

CROSS-LINE LASER
The automatic 3 line laser for professional do-it-yourself enthusiasts
The 3 laser lines are readily visible and outstanding for aligning tiles, wall
studding, windows, doors, etc. The 90° position of the vertical laser lines can
be used to produce a right angle on the floor and project a plumb line on slanted
walls (see Figure C on Pg. 4). Simple handling is made possible by
the magnetically dampened pendulum system – the device levels itself
automatically in seconds. Its height-adjustable bracket makes the SCL 3 truly
versatile – on the tripod, on the wall and on magnetic-responsive objects. The
slope-mode feature is an extra that permits gradients to be laid out. An integrated
transport restraint protects the pendulum system against damage. Precision 3
mm / 10 m.
Includes: soft case and batteries (4 x type AA).

GENERAL SAFETY INSTRUCTIONS

Caution: Do not look directly into the beam. Lasers must be kept out of reach
of children. Never intentionally aim the device at people. This is a quality laser
check the calibration before use, after transport
and after extended periods of storage. We also wish to point out that absolute
calibration is only possible in a specialist workshop. Calibration by yourself is
only approximate and the accuracy of the calibration will depend on the care
with which you proceed.
Note: This is a precision instrument product which must be handled with care.
Avoid impacts and jarring. Always turn off all lasers and latch the pendulum in
place before transporting, ON/OFF switch in its «OFF» position! Clean with a soft
cloth and glass cleaner.
12
Laser 3D CONDTROL
EN
measuring device and is 100%
factory adjusted within the stated
tolerance. For reasons of product
liability, we must also draw your
attention to the following: Regularly
User Manual