Herunterladen Inhalt Inhalt Diese Seite drucken

Message Codes; Safety Regulations - CONDTROL XP3 Bedienungsanleitung

With tilt sensor
Vorschau ausblenden Andere Handbücher für XP3:
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

EN
LASER DISTANCE METER

MESSAGE CODES

While operation, the following codes/symbols may appear on the display:
Message
Cause
ERR 1
Laser signal is too weak
ERR 2
Laser signal is too strong
ERR 3
Low power
ERR 4
Failure of memory
Failure of calculation by
ERR 5
Pythagoras' Theorem
Exceed design measuring
ERR 6
range
ERR 7
Failure of tilt sensor
20
Downloaded from
www.Manualslib.com
XP3 CONDTROL
User manual
Solution
Use a reflector
Use a reflector
Change or recharge batteries
Please contact service center
Please redo measurement
Please change to longer distance
product
Please contact service center
manuals search engine
EN
LASER DISTANCE METER

SAFETY REGULATIONS

The user manual should be read carefully before you use the product for the first
time. Unintended use of the product can be dangerous for human's health and
cause serious injury. Keep this user manual. If the product is given to somebody
for temporary use, be sure to enclose user manual to it.
- Do not misuse the product
- Do not remove warning signs and protect them from abrasion, because they
contain information about safe operation of the product.
The device belongs to laser product class 2 in accordance with EN 60825-1 with a
630-670 nm wavelength.
- Do not look into the laser beam or its reflection, with unprotected eye or
through an optical instrument. Do not point the laser beam at people or animals
without the need. You can dazzle them.
- To protect your eyes close them or look aside.
- It is prohibited to disassemble or repair the product yourself. Intrust product
repair to qualified personnel and use original spare parts only.
- Do not use the product in explosive environment, close to flammable materials.
- Avoid heating the batteries to avoid the risk of explosion and electrolyte
leakage. In case of liquid contact with skin, wash it immediately with soap and
water. In case of contact with eyes, flush with clean water during 10 minutes and
consult the doctor.
XP3 CONDTROL
User manual
21

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis