Technical Data; The Calibration Check - CONDTROL Laser 3D Bedienungsanleitung

CROSS-LINE LASER

TECHNICAL DATA

Automatic levelling range
Accuracy
Operating range (depending on room
illumination)
Laser wavelength
Laser class / line laser output power
Power supply
Dimensions / weight (without wall bracket
and batteries)
Temperature range, operating / storage
Note: Regularly check the calibration before use, after transport and after
extended periods of storage.

THE CALIBRATION CHECK

It is possible for you to check the calibration of the laser. To do this, position
the device midway between 2 walls, which must be at least 5 metres apart. Do
this by turning the unit on, thus releasing the transport restraint (cross laser on).
Please use a tripod.
1. Mark point A1 on the wall.
2. Turn the device through 180° and mark point A2. You now have a horizontal
reference between points A1 and A2.
Laser 3D CONDTROL
± 5°
± 3 mm / 10 m
20 m
635 nm
2M / < 5 mW
4 x 1,5V AA / ca. 20 h
122 x 100 x 70 mm / 0,55 kg
0°C ... +50°C / -10°C ... +70°C
User Manual
15