Message Codes; Safety Regulations - CONDTROL smart 25 Bedienungsanleitung

LASER DISTANCE
Smart 25 CONDTROL
EN
METER
2) Continuous measurement (tracking)
When in single distance measurement mode press and hold
button for 2 seconds. Symbol
on the display. The product will take measurements one
after the other, showing the last measured value. To stop
continuous measurement press button
will automatically stop continuous measurement
seconds after mode activation.

MESSAGE CODES

While operation, the following codes/symbols may appear
on the display:
Message Cause
Received signal is
Err1
too weak
Received signal is
Err2
too strong
Low battery charge
Err3
level
The working
Err4 temperature is out
of working range
Memory is
Err5
damaged
8
User manual
will be blinking
. The product
in 30
Solution
Choose the surface with
stronger reflectance. Use a
reflector.
Choose the surface with
weaker reflectance. Use a
reflector.
Replace batteries.
Use the device in the
specified temperature.
Contact distributor.
LASER DISTANCE
Smart 25 CONDTROL
EN
METER

SAFETY REGULATIONS

The user manual should be read carefully before you use the
product for the first time. Unintended use of the product can
be dangerous for human's health and cause serious injury.
Keep this user manual. If the product is given to somebody
for temporary use, be sure to enclose user manual to it.
- Do not misuse the product
- Do not remove warning signs and protect them from
abrasion, because they contain information about safe
operation of the product.
The device belongs to laser product class 2 in accordance
with EN 60825-1 with a 630-670 nm wavelength.
- Do not look into the laser beam or its reflection, with
unprotected eye or through an optical instrument. Do not
point the laser beam at people or animals without the need.
You can dazzle them.
- To protect your eyes close them or look aside.
- It is prohibited to disassemble or repair the product
yourself. Intrust product repair to qualified personnel and
use original spare parts only.
- Do not use the product in explosive environment, close to
flammable materials.
- Avoid heating the batteries to avoid the risk of explosion
and electrolyte leakage. In case of liquid contact with skin,
wash it immediately with soap and water. In case of contact
with eyes, flush with clean water during 10 minutes and
consult the doctor.
User manual
9