Startup / Operation; Installation - BOMANN KG 2198 Bedienungsanleitung

Kühl-/gefrierkombination

Vorschau ausblenden

Inhalt

Inhaltsverzeichnis

Verfügbare Sprachen

Installation

Condition

Conditions for the installation location

Condition

s for the installation location

• Good ventilation is required around the appliance,

in order to dissipate the heat properly and to

guarantee efficient cooling operation at low power

consumption. Sufficient clearance is necessary.

Gap to the back approx. 5 cm and to the side

walls each approx. 10 cm;

Place the appliance so that the appliance door

can open without being impeded.

• Only install at a location with an ambient tempera-

ture suitable for the climate class of the appliance.

For information on the climate class, please refer

to chapter "Technical Data" or to the rating label

located in the interior or on the rear side of the

appliance.

• Place the appliance on a steady and safe surface.

If the appliance is not horizontally leveled, adjust

the feet accordingly.

• Avoid the installation:

Avoid the installation:

near heaters, next to a stove, direct sunlight or

any other heat sources;

at locations with high humidity (e.g. outdoors,

bathroom), as metal parts would be suscepti-

ble to corrosion under such circumstances;

near volatile or flammable materials (e.g. gas,

fuel, alcohol, paint, etc.), in rooms which may

have poor air circulation (e.g. garages).

Do not expose the appliance any weather.

Electrical connection

WARNING:

• The installation to the mains supply must conform

to the local standards and regulations.

• Improper connection may cause to an electric

shock!

shock

• Do not modify the appliance plug. If the plug does

not fit properly to the outlet, let install a proper

outlet by an authorized specialist.

WARNING:

• The accessibility of the power plug must be en-

sured to disconnect the appliance from the power

supply in case of emergency.

CAUTION: : : :

CAUTION

In case of disconnection or power failure:

Wait for approx. 5 minutes before restarting.

Check the operation settings.

• Ensure that your mains power corresponds with

the specifications of the appliance. The specifica-

tions are printed on the rating label.

• Connect the mains cable to a properly installed

and earthed wall outlet.

• If the plug after installation is not accessible, a

corresponding disconnect device must be availa-

ble to meet the relevant safety regulations.

Prior to first use

CAUTION: : : :

CAUTION

After transport, the appliance should be left standing

upright for about 24 hours before connecting to the

power supply. Nonobservance could lead to malfunc-

tion of the cooling system and causes an appliance

breakdown.

Clean the appliance interior including all accessory

parts. Consider the instructions which we provide in

the chapter "Cleaning and Maintenance".

electric