Charging Procedure/Operating Instructions; Cleaning Instructions; Accessories; Storage - RIDGID micro CA-330 Betriebsanleitung

micro CA-330 Inspection Camera
of either is outside of this range at any
point during charging, the operation will
be suspended until brought back to the
correct temperature range.
• Appropriate power source. Check to
see that the plug fits correctly into the
desired outlet.
• Sufficient ventilation. The charger needs
a clearance of at least 4" (10 cm) on all
sides to maintain a proper operating
temperature.
5. Plug cord into charger.
6. With dry hands, plug charger into the
appro priate power source.
Charging
Procedure/Operating
Instructions
WARNING
Always wear eye protection to protect
your eyes against dirt and other foreign
objects.
Follow operating instructions to reduce
the risk of injury from electrical shock.
NOTE! New batteries reach their full capacity
after approximately 5 charging and dis-
charging cycles.
1. Set up charger according to the Charger
Inspection and Set-Up section.
2. The charger conducts a 1-second life
test during which the LED blinks from
red to green. The charger then goes into
standby mode in which the LED is OFF.
3. With dry hands, insert the battery pack
onto the charger. The battery pack will
begin charging automatically. While the
battery is charging, the red LED will glow
solid.
4. When the battery is fully charged, the
green LED glows solid. Remove the bat-
tery. Once the battery is charged, it may
remain on the charger until it is ready to
be used. There is no risk of over-charging
the battery. When the battery has been
fully charged, the charger automatically
18
switches to retention charging.
5. With dry hands, unplug the charger from
the outlet once charging is complete.

Cleaning Instructions

WARNING
Unplug the charger before cleaning. Do
not use any water or chemicals to clean
charger or batteries to reduce the risk of
electrical shock.
1. If present, remove battery from charger.
2. Remove any dirt or grease from the ex -
terior of the charger and battery with a
cloth or soft non-metallic brush.

Accessories

WARNING
To reduce the risk of serious injury, only
use accessories specifically designed
and recommended for use with the
RIDGID Li-Ion Battery Charger such as
those listed below. Other Accessories
suitable for use with other tools may
be hazardous when used with the
RIDGID Li-Ion Battery Charger.
Catalog
No. Description
37088 micro CA-330 Charger
37083 micro CA-330 3.6V Li-Ion Battery
Further information on accessories specific
to the charger can be found in the RIDGID
Catalog and online at www.RIDGID.com or
www.RIDGID.eu.

Storage

Store the charger and the batteries in a dry,
secured, locked area that is out of reach of
children and people not familiar with proper
charger operation.
The batteries and charger should be protected
against hard impacts, moisture and humidity,
dust and dirt, extreme high and low tempera-
tures and chemical solutions and vapors.
Long-term storage in temperatures
NOTICE
above 104°F (40°C) can permanently reduce
the capacity of the batteries.