Installing Imager Head Cable Or Extension Cables; Installing Accessories; Installing Sd™ Card; Pre-Operation Inspection - RIDGID micro CA-330 Betriebsanleitung

Installing the Imager Head
Cable or Extension Cables
To install imager head or extension cables
(see accessory section), align the socket key
with the socket slot and slide the connec-
torstogether. Secure the connection by tight-
ening the knurled knob (Figure 7) .
Key
Figure 7 – Cable Connections

Installing Accessories

The three included accessories, (Hook, Mag -
net, Mirror) all attach to the imager head the
same way.
Flats
Figure 8 – Installing an Accessory
Slip the semicircle end of the accessory over
the flats of the imager head. Then rotate the
turn to retain (Figure 8) .
accessory a 1 /
4
Installing SD™ Card
Open the left side port cover (Figure 4) to ac-
cess the SD card slot. Insert the SD card into
the slot as shown in Figure 9 . SD cards can
only be installed one way – do not force. When
an SD card is installed, a small SD card icon
will appear in the upper left hand portion of the
screen, along with the number of images or
length of video that can be stored on the SD
card.
Slot
Knob
Accessory
1/4 Turn
micro CA-330 Inspection Camera
Figure 9 – Inserting the SD Card
Pre-Operation
Inspection
WARNING
Before each use, inspect your Inspec -
tion Camera and correct any problems
to reduce the risk of serious injury from
electric shock and other causes and
prevent tool damage.
1. Make sure the unit is OFF.
2. Remove the battery and inspect it for
signs of dam age. Re place battery if nec-
essary. Do not use Inspection Camera if
the battery is damaged.
3. Clean any oil, grease or dirt from the e -
quip ment. This aids inspection and helps
prevent the tool from slipping from your
grip.
4. Inspect micro CA-330 Inspection Camera
for any broken, worn, miss ing or bind-
ing parts or any condition which may
prevent safe and normal operation.
5. Inspect the camera head lens for con-
densation. To avoid damaging the unit, do
not use the camera if condensation forms
inside the lens. Let the water evaporate
before using.
6. Inspect the full length of the cable for
cracks or damage. A damaged cable
could allow water to enter the unit and in-
crease the risk of electrical shock.
7