Operating Instructions; Viewing - RIDGID micro CA-150 Bedienungsanleitung

micro CA-150 Inspection Camera

Operating Instructions

WARNING
Always wear eye protection to protect
your eyes against dirt and other foreign
objects.
Follow operating instructions to reduce
the risk of injury from electrical shock,
entanglement and other causes.
1. Make sure that the inspection camera
and work area have been properly set
up and that the work area is free of by-
standers and other distractions.
Rotate
Image
LED
Brightness Decrease
Figure 8 – Controls
2. Power On: Press and Hold the power
button for 2 seconds. A splash screen
will appear. Once the camera is ready, the
live view will be seen.
If the display does not turn ON, the batter-
ies need to be changed or the unit needs
service.
3. Pre-Form The Cable: If needed for the
area to be inspected, pre-form the cable.
Do not try to form bends with a radius of
less than 2" (50mm), this can damage the
cable.
4. LED Brightness Adjustment: The im-
ager head is equipped with four white
LEDs to aid inspection. Use the + and –
buttons to turn ON and adjust the bright-
ness of the LEDs.
8
Image
Playback
Power
LED Brightness
Increase
Image Capture
5. Inspection: Insert the imager head and
cable into the space to be inspected. Do
not use the imager head or cable for any-
thing other than an inspection device.
Do not use the imag er head and cable to
clear a path. Do not force the imager
head and cable through tight bends or
spaces. These uses can damage the unit
and the area to be inspected.
6. Image Capture: During inspection, press
this button to record an image to internal
memory. Up to 20 images can be cap-
tured by the CA-150 internal memory.
Once 20 images are captured, subse-
quent image captures will overwrite
existing images in memory, starting
with the first.
7 . Image Playback: Pressing this button
will display the most recent image cap-
tured in internal memory. Press this but-
ton again or the + and – buttons to navi-
gate through saved images. Press Image
Capture to return to the live view.
8. Image Delete: To delete the captured
image shown on the display, hold the
Image Playback button for 3 seconds.
Continue to hold the Image Playback but-
ton to delete subsequent images, if de-
sired.
9. Image Rotation: If needed, the image
seen on the screen can be rotated 180
degrees by pressing the rotate image
button.
10. Power Off: When the inspection is com -
plete, carefully withdraw the imager and
cable from the inspection area. Press
and Hold the power button for 1 second to
turn the unit OFF. The unit will automati-
cally turn OFF 30 minutes after the last
button press or if the batteries drop too
low.

Viewing

The micro CA-150 Inspection Camera can be
connected to a television or other monitor for
remote viewing or recording through the in-
cluded RCA cable. Open the rubber cover on
the side of the grip and insert the RCA cable
into the TV-OUT jack.
Insert the other end into the Video In jack on
the television or monitor. The television or
monitor may need to be set to the proper input
to allow viewing.