Image Adjustment; Image Capture; Audio Recording; Menu - RIDGID micro CA-330 Betriebsanleitung

micro CA-330 Inspection Camera
This may result in damage to the Inspec -
tion camera or inspection area.

Image Adjustment

Adjust LED Brightness : Pressing the right
and left arrow button
live screen) will increase or decrease the
LED brightness. A brightness indicator bar
will be displayed on the screen as you adjust
brightness.
Figure 14 – Adjusting LED
Zoom : The micro CA-330 Inspection Camer -
a has a 2.0x digital zoom. Simply press the up
and down arrows
to zoom in or out. A zoom indicator bar will be
displayed on the screen as you adjust your
zoom.
Figure 15 – Adjusting Zoom
Image Rotation : If needed, the image/video
seen on the screen can be rotated in 90 de-
gree increments counter clockwise by press-
ing the rotate image button

Image Capture

If an SD card is installed, images will be stored
there. Otherwise, internal memory will be used.
Capturing a Still Image
While in the live screen, make sure the still
10
on the button pad (In
while in the live screen
.
camera icon is present at the top left por-
tion of the screen. Press the shutter button to
capture the image. The save icon
mentarily appear on the screen. This indi-
cates the still image has been saved.
Capturing a Video
While in the live screen, make sure the video
camera icon is present at the top left por-
tion of the screen. Press the shutter button to
start capturing video. When the device is
recording a video, a red outline will flash
around the video mode icon and the recording
duration will show at the top of the screen.
Press the shutter button again to stop the
video. It may take several seconds to save
the video. The menu cannot be accessed
when recording.
Figure 16 – Video Recording Screen

Audio Recording

When recording video, audio will be recorded
if the microphone is on. Audio can be added
through
• The integrated microphone under the
right side port cover.
• The included headset/microphone. When
plugged into the audio port on the right
side of the camera, this will be used in-
stead of the integrated microphone.
• A Bluetooth microphone. See "Using a
Bluetooth ® Microphone" on Page 13. When
paired with the camera and connected,
this will be the primary microphone.
5. When the inspection is complete, care-
fully withdraw the camera and cable from
the inspection area.

Menu

Pressing the Menu button
access the menu. The menu will overlay on the
will mo-
at any time will