Icons; Tool Assembly; Changing/Installing Batteries; Powering With The Ac Adapter - RIDGID micro CA-330 Betriebsanleitung

micro CA-330 Inspection Camera
ion Camera conforms to all applicable EMC
standards. However, the possibility of it caus-
ing interference in other devices cannot be
precluded.

Icons

Battery Life Indicator – Fully charged
battery.
Battery Life Indicator – Less than 25%
of battery charge remains.
SD™ Card – Indicates an SD card has
been inserted into the device.
Still Camera – Indicates device is operat-
ing in still camera mode.
Video Camera – Indicates device is oper-
ating in video camera mode.
Playback Mode – Selecting this icon al-
lows you to view and delete previous ly
saved images and video.
Menu – Push select on this icon to be
taken to the menu screen.
Select – Pressing select from the live
screen will take you to the playback screen.
Return – Pressing return from the live
screen will switch between camera and
video. Return will also back out of menu
and playback mode.
LED Brightness – Press right & left ar-
rows to change the LED brightness.
Zoom – Press up & down arrows to
change the zoom from 1.0x to 2.0x.
Save – Indicates image or video has
been saved to memory.
Trash – Delete confirmation icon.
Mode – Select between image, video or
playback.
Time Stamp – Select to display or hide
date and time on live screen.
Language – Choose between, English,
French, Spanish, German, Dutch, Italian,
etc.
Time and Date – Enter this screen to set
time and date.
TV – Chose between NTSC and PAL to
enable TV out video format.
Update Firmware – Use to update unit
with most current software.
Speaker/Microphone – Turns speaker
and microphone ON or OFF during
recording and playback.
Automatic Power OFF – Device will
automatically shut down after 5, 15 or
60 minutes of inactivity.
Factory Reset – Restore factory defaults.
Bluetooth ® – Turn ON or OFF ability to
connect to a Bluetooth microphone.
Wi-Fi – Turn ON or OFF Wi-Fi broadcast.
About – Displays software version.
6

Tool Assembly

WARNING
To reduce the risk of serious injury dur-
ing use, follow these procedures for
proper assembly.

Changing/Installing Batteries

The micro CA-330 is supplied without the
battery installed. If the battery indicator dis-
plays , the battery needs to be recharged.
Re move the battery prior to long term storage
to avoid battery leakage.
1. Squeeze the battery clips (See Figure
5) and pull to remove battery compart-
ment cover. If needed, slide battery out.
Figure 5 – Battery Compartment Cover
Figure 6 – Removing/Installing Battery
2. Insert contact end of battery into the in-
spection tool, as shown in Figure 6 .
3. Replace battery compartment cover.

Powering with the AC Adapter

The micro CA-330 Inspection Camera can al -
so be powered using the supplied AC Adapter.
1. Open the right side port cover (Figure 3).
2. Insert the AC adapter barrel plug into
the port marked "DC 5V".
3. With dry hands, plug the AC adapter into
the outlet.