Electric Connection; Disposing Of The Packaging; Disposing Of Your Old Refrigerator; Placing And Installation - Beko CN 153920 Handbuch

Electric connection

Connect your product to a grounded
socket which is being protected by a fuse
with the appropriate capacity.
Important:
• The connection must be in compliance
with national regulations.
• The power cable plug must be easily
accessible after installation.
• The specified voltage must be equal to
your mains voltage.
• Extension cables and multiway plugs
must not be used for connection.
B
A damaged power cable must be
replaced by a qualified electrician.
B
Product must not be operated before
it is repaired! There is danger of electric
shock!

Disposing of the packaging

The packing
dangerous for children. Keep the packing
materials out of the reach of children or
dispose of them by classifying them in
accordance with the waste instructions.
Do not dispose of them along with the
normal household waste.
The packing of your refrigerator is
produced from recyclable materials.
Disposing of your old
refrigerator
Dispose of your old refrigerator without
giving any harm to the environment.
• You may consult your authorised dealer
or waste collection center of your
municipality about the disposal of your
refrigerator.
Before disposing of your refrigerator, cut
out the electric plug and, if there are any
locks on the door, make them inoperable
in order to protect children against any
danger.
materials may

Placing and Installation

A
If the entrance door of the room
where the refrigerator will be installed is
not wide enough for the refrigerator to
pass through, then call the authorised
service to have them remove the doors
of your refrigerator and pass it sideways
through the door.
1. Install your refrigerator to a place that
allows ease of use.
2. Keep your refrigerator away from
heat sources, humid places and direct
sunlight.
3. There must be appropriate air
ventilation around your refrigerator in
order to achieve an efficient operation. If
the refrigerator is to be placed in a recess
in the wall, there must be at least 5 cm
distance with the ceiling and at least 5 cm
with the wall. If the floor is covered with
a carpet, your product must be elevated
2.5 cm from the floor.
4. Place your refrigerator on an even
be
floor surface to prevent jolts.
5. Do not keep your refrigerator in
ambient temperatures under 10°C.

Adjusting the legs

If your refrigerator is unbalanced;
You can balance your refrigerator by
turning its front legs as illustrated in the
figure. The corner where the leg exists is
lowered when you turn in the direction of
black arrow and raised when you turn in
the opposite direction. Taking help from
someone to slightly lift the refrigerator will
facilitate this process.
9
EN