Initial Device Startup; Installing The Device - Stryker Flosteady Handbuch

4

Initial Device Startup

4.1

Installing the Device

Always check all parts and accessories of the device immediately after receiving
the shipment. The manufacturer considers only replacement claims that have
been immediately submitted or reported to a sales representative or an autho-
rized service company.
If it becomes necessary to return the device, always use the original packaging.
The manufacturer does not take responsibility for damage that has occurred dur-
ing transportation if the damage was caused by inadequate transport packaging.
Please fill out the return form enclosed at the end of the instructions. Enclose the
manual with the device.
Please make sure that all required information has been supplied:
• Name of owner
• Address of owner
• Device type and model
• Serial number (see identification plate)
• Description of defect
Place the device on a level surface and install in a dry environment. The ambient
temperature and humidity must meet the requirements mentioned in chapter
13 "Technical Data".
The rod diameter of the stand can range from 20 to 32 mm.
WARNING!
Please read the instruction manual for the stand before mounting the pump on
the stand.
Initial Device Startup
Delivery inspection
Returning the device
Setting up the device
Attach to stand
Fig. 4-1 Attaching device to stand
EN
11