Parkside PDSSA 12 A1 Originalbetriebsanleitung Seite 42

Battery pack: PAP 12 A2
Type:
Rated voltage:
Cells:
Capacity:
High-speed battery charger: PLG 12 A2
INPUT:
Rated voltage:
Power consumption:
OUTPUT:
Rated voltage:
Rated current:
Charging time:
Fuse (internal):
Protection class:
Noise emission value:
Noise measurement value determined in accordance
with EN 60745 . The A-rated noise level of the
power tool is typically as follows:
Sound pressure level:
Uncertainty K:
Sound power level:
Uncertainty K:
Vibration emission value:
Total vibration values (vector total of three direc-
tions) determined in accordance with EN 60745:
Tightening screws and nuts of maximum permissible
size:
a = 6 .9 m/s
2
h
Uncertainty K = 1 .5 m/s
Wear ear protectors!
PDSSA 12 A1
LITHIUM ION
(DC)
12 V
3
2000 mAh
230–240 V ~ (AC), 50 Hz
38 W
(DC)
12 .6 V
2 .4 A
approx . 60 min
2 A
T2A
II / (double insulation)
L = 90 dB (A)
PA
K = 3 dB
PA
L = 101 dB (A)
WA
K = 3 dB
WA
2
NOTE
► The vibration level specified in these instruc-
tions has been measured in accordance with
a standardised measuring procedure and
can be used for equipment comparisons . The
specified vibration emission value can also
be used to make an initial exposure estimate .
WARNING!
► The vibration level varies depending on the
use of the power tool and may, in some cases,
be higher than the value specified in these
instructions . Regular use of the power tool in
this way may cause the user to underestimate
the vibration . Try to keep the vibration loads
as low as possible . Measures to reduce the
vibration load are, e .g . wearing gloves and
limiting the working time . Wherein all states of
operation must be included (e .g . times when
the power tool is switched off and times where
the power tool is switched on but running
without load) .
GB │ MT │ 39 ■