Maintenance - Jacuzzi J-Sha MI Bedienung Und Wartung

Maintenance

■
Tub maintenance is quick and easy. You need only any neu-
tral non-abrasive liquid detergent, which can also be used to
clean the remote control.
Do not use abrasive cloths, powder detergents, ace-
tone or other solvents.
■ The tub can be regularly polished using an ordinary polish..
■
I n the event of scratches or considerable damage, it is nec-
essary to contact a Jacuzzi
■
HYDROMASSAGE OUTLETS
•
Remove the flange cover (1), using a wide-edged screwdriver
as a lever under the edge.
• Using the wing nuts, or the cone-shaped spanner (2) provided,
remove the ring nut (3) and the nozzle (4).
•
Remove any deposits and wash all the components with water
and liquid soap.
• Repeat the previous phases in reverse order, making sure that
you tighten the ring nut (3) well.
NOTE NOTE
During cleaning operations, the nozzle (4) can also be disman-
tled, but make sure that you do not lose the spring clip inside it.
® Service Centre.
■
SUCTION INTAKE
• Remove the screw and the cover (the latter has a washer on
the back as shown in the figure ).
• Clean the inlet compartment with a strong jet, using liquid
soap; make sure to clean the flap seal and the valve at the
bottom.
• Then replace the cover, making sure that the washer fits well
into place, on the back of the cover.
■
Any supplementary maintenance operations (electro-mechan-
ical parts and/or electronic components under the tub rim,
scratches or marks on acrylic parts, etc.) are the exclusive re-
sponsibility of qualified personnel; in this case, only contact Au-
thorized Jacuzzi ® Service Centres.
■
For all maintenance and/or repair operations that require the
replacement of components, original Jacuzzi
be used. Failure to comply with this regulation while carrying
out this operation will mean that the Manufacturer is not liable
for any damage that may occur.
Jacuzzi Europe SpA recommends that you contact your local
Jacuzzi ® Service Centre for all operations and intervention not
covered in this manual.
112
® spare parts must