Maintenance; Suction Nozzles - Jacuzzi Designer Collection Serie Bedienung Und Wartung

I
The sanitisation cycle stops before the end
When the LED of the corresponding button starts blinking,
you have five minutes to add disinfectant: the cycle will restart
and continue to the end of the programmed ten minutes.
Otherwise, the cycle will be stopped (the LED will continue to
blink for approximately 60 minutes).
If a beep is emitted, it means that the water level in the tub is
low (refer to the specific chapters).
SHOWER ZONE
I
No water from the various functions (shower, etc.)
Check that the mixer is open; in models with thermostat
mixer, also check that the stop tap is open and that the filters
are not obstructed (see "Installation manual - Disassembling
and cleaning the thermostat valve").
I
Little water from all functions
Check that the plumbing system complies with the pressure
values shown on the pre-installation sheet. In models with
thermostat mixer, check that the filter are not obstructed (see
"Installation manual - Disassembling and cleaning the
thermostat valve").
I
Low pressure from shower/vertical hydromassage
Clean the filter located between shower and hose.
Clean the nozzles (see "Maintenance" chapter).
In models with thermostat mixer, check that the filter are not
obstructed (see "Installation manual - Disassembling and
cleaning the thermostat valve").
I
Difficulty in adjusting water temperature (mixing)
Check that the pressure value between hot and cold water
are balanced.

Maintenance

TUB ZONE

Suction nozzles

27
i
I
( 27) Remove the screw and cover (be careful not to release
the clip of the inside flap).
I
Clean the nozzle compartment with a strong jet of water and
liquid soap, if required. Be careful to clean the seal of the hatch
and the valve on the bottom.
I
Then refit the cover making sure that the o-ring is inserted well
in its housing.
Hydromassage nozzles
4
28
i
I
( 28) Remove the flange cover (1) by levering under the
edge with a wide flat tipped screwdriver.
I
Remove the ring (3) and the nozzle (4) by releasing the tabs
or using the conical tool (2) provided.
I
Remove residues and wash the various components with
water and liquid soap. The nozzle can be removed: be careful not
to loose the clip inside.
33
2
3
1