Use & Maintenance - Jacuzzi energy Bedienung Und Wartung

5-6 cm
1
3
HYDROMASSAGE
Turn on the main switch and wait a few seconds until the
start-up process has completed.
NOTE: check that there are no objects resting on the control
panel (located above the tub edge).
To activate the hydromassage, press the
tub edge); repeat to disable this function.
NOTE: the hydromassage will turn itself off automatically after 20
minutes.
We recommend leaving the hydromassage active for a dura-
tion of 15-20 minutes (5-10 minutes are necessary before the ac-
tion of the moving water begins to take effect).
We recommend setting the water temperature at approxi-
mately 36 °C; in the instance of higher temperatures, it is advis-
able to reduce the duration of the hydromassage:
34-36 °C --> 20 minutes of hydromassage
36-38 °C --> 15 minutes of hydromassage
38-40 °C --> 10 minutes of hydromassage
2
4
Soap and bath foams (where not used as part of hydromas-
sage) must only be used when the hydromassage is not in
use.
Always turn off the hydromassage and main switch before
emptying the tub.
button (on the
LIGHT (where present)
To switch on the light, press the
(on the tub edge).
To switch it off, press down the button until the light goes out.
It is possible to have either a white or coloured light; a light
which changes colour assuming different sequences is also
available.
The colour sequences are as follows:
- Cromodream (based on a mixed colour sequence);
- Relax (based on a blue colour sequence);
- Energy (based on a red colour sequence).
9 9
button for a few seconds