Before The First Use - Vitek VT-1502 BK Betriebsanweisung

www.101kofemashina.ru - обзоры, отзывы, характеристики, инструкции, акции и цены
ENGLISH
danger that can be caused by its improper
usage.
• Do not leave children unattended to prevent
using the unit as a toy.
•
For children safety reasons do not leave poly-
ethylene bags, used as packaging, unat-
tended.
Attention! Do not allow children to play with
polyethylene bags or packaging film. Danger of
suffocation!
• Check the power cord, the power plug and the
unit body integrity periodically.
•
Never use the unit if the power cord or the
power plug is damaged, if the unit works
improperly or after it was dropped or in case
of any damages.
•
Do not attempt to repair the unit. Do not disas-
semble the unit by yourself, if any malfunction
is detected or after it was dropped, unplug
the unit and apply to any authorized service
center from the contact address list given in
the warranty certificate and on the website-
www.vitek.ru.
• Transport the unit in the original package only.
• Keep the unit out of reach of children and dis-
abled persons.
THE UNIT IS INTENDED FOR HOUSEHOLD
USAGE ONLY

BEFORE THE FIRST USE

After unit transportation or storage at low
temperature keep it for at least three hours
at room temperature before switching on.
Note: There may be water spots in the tank.
This is normal, as the unit has undergone factory
quality control.
Unpack the coffee maker, remove any stick-
–
ers and package materials that can prevent
unit operation.
Check the unit for damages; do not use it in
–
case of damages.
Make sure that operating voltage of the unit
–
corresponds to the voltage of your mains.
Before using the coffee maker for the first
–
time wash all the removable parts, the fil-
ter holder (5), the coffee filter (6), the water
tank (11) and the measuring spoon (18) with
warm water and a neutral detergent and then
dry them.
Wash the water supply system and the cap-
–
puccinator pipe.
VT-1502.indd 4
www.101kofemashina.ru помогает выбирать кофейную технику с 2010 г.
Washing the water supply system
• Make sure that the operation mode selection
knob (14) is set to the position « », and the
water/steam supply button (7) is not pressed
(is set to the position
•
Before washing fill the water tank (11) with water.
• Hold the handle (10) and remove the water
tank (11).
•
Open the lid (9) of the water tank (11) and fill
the tank with cold water up to the «MAX» mark.
After that install the water tank (11) back to its
place and cover it with the lid (9).
•
Insert the coffee filter (6) into the holder (5),
matching the ledge on the filter (6) with the
slot on the holder (5) and turn the filter (6)
clockwise/counterclockwise (pic. 1, 2).
•
Without adding coffee into the filter (6), attach
the filter holder (5) to the coffee maker boiler;
to do this, place the filter holder handle (3)
under the inscription «INSERT» on the cof-
fee maker body, insert the holder (5) into the
boiler and turn the filter holder handle (3) in
the direction of the inscription «LOCK» (coun-
terclockwise) as far as it will go (pic. 3, 4)
• Place a suitable bowl (with a capacity of no
less than 400 ml) on the tray grid (2).
•
Insert the power plug into the mains socket.
Press the button (17) to switch the coffee
maker on, the indicator (12) will light up red.
•
Set the operation mode selection knob (14) to
the position « ». Wait until water is delivered
from the outlet openings of the filter holder
(5) and then set the operation mode selec-
tion knob (14) to the position « ». Make sure
that the water/steam supply button (7) is not
pressed (is set to the position
• After the indicator (13) lights up blue, switch
the water supply on again by setting the oper-
ation mode selection knob (14) to the position
« ». Pour water out for 1 minute and then
stop the water supply by setting the opera-
tion mode selection knob (14) to the position
« ». Wait until water stops pouring from the
filter holder (5) outlet openings and pour it
out from the bowl. The water supply system
washing is over.
Note: When the water supply is switched on for
the first time, a loud sound of the operating pump
and noticeable vibration of the coffee maker
body is possible, but in 20-30 seconds, when the
pump is filled with water, the sound and vibration
level will decrease significantly.
4
).
).
08.02.2016 10:25:59