Vitek VT-1502 BK Betriebsanweisung Seite 7

www.101kofemashina.ru - обзоры, отзывы, характеристики, инструкции, акции и цены
Note: The next time you make coffee, let the
coffee maker boiler cool down to required tem-
perature to avoid the smell of burnt coffee. Place
a suitable cup (with a capacity of no less than
250 ml) on the tray grid (2). Press the water/
steam supply button (7) (position «
set the operating mode selection knob (14) to the
position « ». The pump will start running cold
water through the boiler. Run water through the
broiler until the ready indicator (13) goes out. After
that close the water supply (set the operation
mode selection knob (14) to the position « ») and
wait until the indicator (13) lights up blue again.
Important:
•
It is important that milk for making milk froth
is fresh and without additives, therefore so-
called long storage milk is not suitable for
this purpose. Take ordinary whole milk with
fat content from 4 to 6%, cream fat content
should be not less than 10%.
WARMING THE DRINKS
You can warm up your drinks by putting the cap-
puccinator pipe (15) without the tip (16) into the
cup with the drink.
•
Remove the tip (16) from the cappuccinator
pipe (15).
•
Make sure that the operation mode selection
knob (14) is set to the position « », and the
water/steam supply button (7) is not pressed
(is set to the position
• Make sure that there is enough water in the
water tank (11).
•
Insert the power plug into the mains socket.
Press the button (17) to switch the coffee
maker on, the indicator (12) will light up red.
• Set the operation mode selection knob (14) to
the position « ». Wait until water is delivered
from the outlet openings of the filter holder
(5) and then set the operation mode selection
knob (14) to the position « ».
• Press the button (7) (position «
until the indicator (13) lights up yellow.
• Draw the cappuccinator pipe (15) into the cup
with the drink you want to warm up.
•
Switch the steam supply on by setting the
operating mode selection knob (14) to the
position « ».
• After warming up the drink set the operation
mode selection knob (14) to the position « ».
• Switch the coffee maker off by pressing the but-
ton (17), the indicators (12) and (13) will go out.
VT-1502.indd 7
www.101kofemashina.ru помогает выбирать кофейную технику с 2010 г.
Note: The first portion of steam may contain
some water; to obtain dry water steam it is nec-
essary to release the steam into an appropriate
container during several seconds.
») and then DESCALING
For effective operation of the coffee maker we
recommend to remove scale every month and
more often when you use «hard» water.
Regular descaling extends the coffee maker
operating life and decreases the hazard of dam-
aging the unit.
Untimely descaling, as well as non-observance
of these instructions and mishandling the coffee
maker are not covered by warranty.
•
•
•
•
•
•
1.
).
2.
3.
») and wait
4.
7
ENGLISH
Prepare a citric acid solution (2 tea spoons per
1 liter of water).
Make sure that the operation mode selection
knob (14) is set to the position « », and the
water/steam supply button (7) is not pressed
(is set to the position ).
Place a suitable bowl on the tray grid (2).
Hold the handle (10) and remove the water
tank (11).
Open the lid (9) of the water tank (11). Fill the
water tank (11) with the prepared solution up to
the «MAX» mark. After that install the water tank
(11) back to its place and cover it with the lid (9).
Follow the steps 1-8 here of.
Press the button (17) to switch the coffee
maker on, the indicator (12) will light up red.
Set the operation mode selection knob (14)
to the position « ». Make sure that the
water/steam supply button (7) is not pressed
(is set to the position
is delivered from the outlet openings of the
filter holder (5) and then set the operation
mode selection knob (14) to the position « ».
The coffee maker will start heating up.
After the indicator (13) lights up blue, set the
operation mode selection knob (14) to the
position « », the solution will start filling
the bowl. When the bowl is filled with approx-
imately 100 ml of liquid, set the operation
mode selection knob (14) to the position « »
and wait for 5 seconds.
Press the button (7) (position «
until the indicator (13) lights up yellow. Place
the bowl under the cappuccinator pipe (15).
Set the operation mode selection knob (14)
to the position « » and release the steam for
2 minutes; then set the operation mode selec-
tion knob (14) to the position « ».
). Wait until water
») and wait
08.02.2016 10:26:00