Vitek VT-1502 BK Betriebsanweisung Seite 6

www.101kofemashina.ru - обзоры, отзывы, характеристики, инструкции, акции и цены
ENGLISH
knob (14) to the position «
being filled with ready coffee.
•
After the cup is filled with coffee, switch the
water supply off by setting the operating
mode selection knob (14) to the position « ».
• After you remove the cup with the coffee,
some water may drip from the filter holder
openings. It is normal. Control the tray (1) fill-
ing, periodically pour out the liquid from it and
wash the tray (1) with water.
Attention!
Do not remove the filter holder (5) during cof-
–
fee maker operation.
Notes:
Successive making of coffee should be per-
–
formed with an at least 5 min interval.
Use only clear water for making coffee and
–
keep the water tank (11) clean.
Before making coffee wait until the blue indi-
–
cator (13) lights up, showing that the water
temperature in the boiler has reached the
required value.
During the coffee maker operation the indi-
–
cator (13) will go out and light up again peri-
odically, indicating the heating element
operation. This operation mode keeps the
boiler temperature within the set range.
• Switch the coffee maker off by pressing the but-
ton (17), the indicators (12) and (13) will go out.
• Wait until the coffee maker cools down and
remove the filter holder (5).
• To remove the filter holder (5), turn the handle
(3) in the direction of the inscription «INSERT»
on the coffee maker body and remove the
holder (5).
•
Lift the filter clamp (4) and, holding the filter
(6) with it, turn the holder (5) upside down and
remove ground coffee remnants.
•
Turning the filter (6) clockwise or counter-
clockwise, remove the filter (6) from the
holder (5) and wash it.
HOW TO MAKE A GOOD ESPRESSO
• Use fresh ground coffee for «espresso» cof-
fee makers.
•
Slightly tamp the ground coffee in the filter
(6), you can do it with the back side of the
measuring spoon (18).
• Coffee strength depends on the quality and
grinding degree of coffee beans.
• If coffee is pouring out too long, this means
the coffee powder is too fine or it is tamped
too strongly.
VT-1502.indd 6
www.101kofemashina.ru помогает выбирать кофейную технику с 2010 г.
MAKING CAPPUCCINO
». Watch the cup
Make coffee, as described in the section
«MAKING ESPRESSO», in a cup with enough
capacity to add frothed milk or cream.
Note: The first portion of steam may contain
some water; to obtain dry water steam it is nec-
essary to release the steam into an appropriate
container during several seconds.
Attention! When switching the steam supply
mode on, be careful to avoid burns by hot water
drops and hot steam.
• Make sure that there is enough water in the
water tank (11).
• Press the water/steam supply button (7)
(position «
(13) lights up yellow. Place a suitable cup
under the cappuccinator pipe (15).
•
Switch the steam supply on by setting the
operation mode selection knob (14) to the
position «
•
Wait until some water pours from the cappuc-
cinator pipe (15), after that steam will go out
more intensively; switch the steam supply off
by setting the operating mode selection knob
(14) to the position « ».
• Take a narrow high tumbler (preferably a
metal one), and fill it with cold milk or cream
approximately by 1/3.
•
Draw the cappuccinator pipe tip (16) into the
tumbler, immersing it into milk by approximately
2 cm, and set the operating mode selection
knob (14) to the position «
cappuccinator pipe should not touch the bot-
tom of the tumbler, as thiscan prevent the steam
release. With certain skill you can make frothed
milk in several seconds.
•
Switch the steam supply off by setting the
operation mode selection knob (14) to the
position « ».
• Clean the cappuccinator pipe (15) and its tip
right after milk or cream frothing – to do this,
draw the cappuccinator pipe with the tip into
a glass of water, switch the steam supply on
by setting the operation mode selection knob
(14) to the position «
the steam supply off (set the operation mode
selection knob (14) to the position « »).
•
Switch the coffee maker off by pressing the but-
ton (17), the indicators (12) and (13) will go out.
• Wait until the coffee maker cools down and
detach the tip (16) of the cappuccinator pipe
(15), turning the tip (16) in different directions
and wash it under a water jet.
6
») and wait until the indicator
».
». The tip of the
», and after that switch
08.02.2016 10:26:00