Pan & Tilt Connection To Control Units; Pan & Tilt Connection To Dtrxdc Receiver; Preset Connection To Dtrxdc Receiver - Videotec Pth355P Bedienungsanleitung

Pan & tilt connection to control units
In the following drawing, identify the terminal block J1 in the lower printed circuit for the pan & tilt connection to
the control units:
Pan & tilt connection to DTRXDC receiver
Where to operate: J1 terminal block in the upper printed circuit of the pan & tilt motor (see drawing), J1 terminal block
of the receiver (see DTRXDC manual)
Adjustments: connect the terminal block J1 of the pan & tilt motor to that of the receiver according to the following
table

Preset connection to DTRXDC receiver

Where to operate: J4 terminal block in the upper printed circuit of the pan & tilt motor, J3 terminal block of receiver
(see DTRXDC manual)
Adjustments: connect the J4 terminal block of the pan & tilt motor to the terminal block of the receiver according to the
following table:
Terminal block J3 of DTRXDC
Vcc
Pan
Tilt
Gnd
Terminal block J1 of DTRXDC Terminal block J1 (Pan & Tilt)
PAN +
PAN -
TILT +
TILT -
Pan +
Pan -
Tilt +
Tilt -
Meaning Terminal block J4 (Pan & Tilt)
+5 Volt Vcc
Horizontal Pan
Vertical Tilt
0 Volt Gnd
Pag. 7 MNPTH3553803