Benelli TnT CenturyRacer Benutzerhandbuch Seite 164

5 • ADJUSTMENT
5.5.1 Adjusting rear suspension spring preload
Adjust the spring preload by means of the two ring nuts (A and B) shown in the figure. Unloose the ring nut (A) and adjust the
preload using the ring nut (B). Turn clockwise for a stiffer preload.Turn anticlockwise for a softer preload.Once the adjustment is over,
tighten the ring nut (A).
5.5.2 Adjusting rear suspension rebound damper hydraulic device
Adjusting of the rebound damper hydraulic device is madein jerks. Turn the rule (C) clockwise to increase the braking action, or turn
anticlockwise to decrease it.
5.5.3 Adjusting device hydraulic braking the rear suspension compression.
The setting of the hydraulic braking compression is done in increments separately for high and low speed. Turn control clockwise (D
- for high and low speed) to increase the braking action, or turn it counterclockwise to decrease.
A
B
5.5.1
C
5.5.2
55
ADJUSTMENT
5.5.3
D
E