Video Source; Connecting A Video Printer - NDS EndoVue Plus 24" Benutzerhandbuch

Video Source

Inputs Menu
When the display is powered on and
previously selected input first. If a signal is present it is displayed, otherwise
scanning the inputs for a signal. When the display is powered on and
previously selected input is the only input that the display looks at.
To switch to a different input source, press the INPUT button to open the input menu. The Input menu
shows: a P to the left of the active input. Press the SCROLL button to highlight the desired input. Finally,
press the fi button to select it.

Connecting a Video Printer

A video printer may be connected via the
VGA/RGBS connector (shown on page 2) or the
S-Video connector (shown on page 2).
Use the VGA/RGBS connector to connect an
VGA/RGBS connector is also used to connect a
Do not use the DVI-I/RGBS connector.
5
Auto Source Select is on, then
RGBS signal. Select the
YPbPr signal. Select the
Auto Source Select
Auto Source Select
Auto Source Select
VGA/RGBS from the input menu. The
YPbPr from the input menu.
looks at the
starts
is off, the