Inserting The Print Paper - Sony DPP-M55 Bedienungsanleitung

Inserting the print paper

You can use the print paper with the
Insert the print paper only one sheet at a time.
1
Connect the supplied power cord,
and turn on the power.
Power cord
(supplied)
to the wall outlet
2
Send the print command from the
computer or Sony digital still
camera.
First the data transmission indicator starts
flashing and then the print paper indicator starts
flashing.
3
Insert a sheet of print paper into
the paper inlet until less than 2 cm
(13/16 inches) of the print paper is
left out of the paper inlet.
The print paper automatically loaded into the
printer.
6
Getting Started
(GB)
VP mark.
Power switch
Less than 2 cm
(13/16 inches)
Notes
• Do not touch the printing surface (the side where nothing is
printed).
• Do not place the print paper in a dusty location. Fingerprints
or dust on the printing surface may result in imperfect
printing.
• Use the print paper recommended for this printer only. If you
use a different type of paper, it may cause problems and the
printer may not print properly.
• To prevent paper from jamming, do not insert another sheet
of print paper before you take out the printout.
• Do not hand-write or type an address or other characters or
drawings in the reverse side of the print paper before
printing. This may cause paper jamming, or failure in
printing.
• You cannot type on the printing surface; use an oil ink pen to
write greetings or other characters or drawings on the
printing surface.