Herunterladen Inhalt Inhalt Diese Seite drucken

CAME PLACO-VC 001CS2PLC0 Programmierhandbuch Seite 22

Vorschau ausblenden Andere Handbücher für PLACO-VC 001CS2PLC0:
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 26
beep
»
beep
¿
VA/01
PROG
PROG
A
<1''
VA/01
PROG
PROG
A
>3''
º
1 P.E
PROG
M1
M1
SW3
BOUT
BOUT
¾
M2
1 P.E
PROG
M1
M1
SW3
EN
BOUT
BOUT
µ
M2
VA/01
PROG
PROG
<1''
A
10
Call button programming
Release by pressing the button
button
associate with the internal extensions : a beep will show that it has been memorised.
Press the PROG button
This operation can only be performed from the entry panel with acoustic signalling active (PE1 in ):
to change the entry panel from which the call programming is performed, press one call button for at
least 3s.
´
Exiting programming
Briefl y press the PROG button: the PROG LED goes off and the entry panel stops ringing.
N.B. If no action is performed, the procedure will automatically end after 30 minutes.
M1
Programming button type
During the "Programming call type" stage press and hold down on the power supplier PROG but-
ton until accessing the "Programming button type" procedure
entry panels to be reprogrammed, the backlighting leds on the call buttons
M1
the operation on all the entry panels to be reprogrammed and .
If all entry panels are reprogrammed, the confi guration will be as illustrated in fi gure .
To exit reprogramming, briefl y press the PROG button on the power supplier : the PROG LEDs and the
button backlighting LEDs will go off .
If no action is performed, the procedure will automatically end after 30 minutes.
2 P.E
3 P.E
PROG
PROG
M1
SW3
SW3
BOUT
M2
M2
2 P.E
3 P.E
PROG
PROG
M1
M1
SW3
SW3
BOUT
BOUT
¸
M2
M2
M1
on the panel to be programmed
e and the AUX2 button at the same time. On the entry panel, press the call button to
and continue, repeating the same operations for all the other extensions.
beep
beep
1 P.E
2 P.E
3 P.E
PROG
PROG
M1
M1
SW3
SW3
BOUT
BOUT
M2
M2
When adding, replacing or removing an entry panel, the acquisition of the mo-
difi cations is done during the "Programming button type" stage (from fi gure
to
).
and press the door release
²
. Press one of the call buttons for the
will stop fl ashing. Repeat
1 P.E
2 P.E
beep
PROG
PROG
M1
M1
SW3
SW3
BOUT
BOUT
¹
M2
M2
3 P.E
PROG
PROG
M1
SW3
SW3
BOUT
M2
M2

Werbung

Inhaltsverzeichnis
loading

Diese Anleitung auch für:

Placo-c 001cs1plc0

Inhaltsverzeichnis