Programming An Intercom Group; Disabling The Intercom Function - CAME PLACO-VC 001CS2PLC0 Programmierhandbuch

M1
º
M1
BOUT
BOUT
M1
M1
BOUT
¾
BOUT
M1
BOUT
µ

PROGRAMMING AN INTERCOM GROUP

Programming of the intercom group must only take place AFTER assigning a call button to all the extensions.
M1
BOUT
M1
³
SW3
BOUT
M2
M1
·
M1
BOUT
BOUT
M2
EN
»

Disabling the intercom function

M1
BOUT
³
M1
BOUT
·
6
Programming button type
>3'' At the "Programming Call Buttons" stage, press the PROG button for at least 3 seconds and release
<6''
it (within 6 seconds) as soon as the PROG LED comes on and the backlighting on the buttons fl ashes as
PROG PROG
shown in fi gure , entring the "Programming button type" procedure.
Press the fi rst button on the entry panel in the position marked until the backlit LEDS stop fl ashing
PROG
M2
SW3
SW3
At the end, to exit programming, briefl y press the PROG button : the PROG LED goes off .
If no action is performed, the procedure will automatically end after 30 minutes.
M2
PROG
PROG
M2
SW3
SW3
M2
PROG
SW3
¸
M2
With the jumper SW3 connected, press the PROG button for at least 8 seconds and release it (within 11
PROG
seconds) as soon as the PROG LED fl ashes and the backlighting
>8''
on the buttons comes on as shown in fi gure .
<11''
To enable the intercom function, go to the internal extension that you want to program and press the
PROG
call button to be used to intercom call it: an acoustic signal will confi rm the programming . Continue
SW3
by repeating the same operations for all the other internal extensions to be included in the intercom
group.
At the end, briefl y press the PROG button .
M2
N.B. If no action is performed, the procedure will automatically end after 30 minutes.
PROG PROG
of a call button, it can no longer be excluded from the group. If you want to change the call but-
ton for an internal extension that is already programmed as intercommunicating
or add new internal extensions to the group, simply repeat the sequence of steps described for
PROG
M2
"Programming an intercom group".
SW3
SW3
3 beep
M1
¿
BOUT
PROG
To deactivate the intercom function, you simply have to disconnect the SW3 jumper ; by doing this,
programming of the intercom system is also inhibited.
SW3
To re-activate this same function, simply re-insert the SW3 jumper .
PROG
M2
SW3
M2
and remain lit.
PROG
M1
SW3
BOUT
M2
Once an internal extension has been included in an intercom group through the assignment
M1
PROG
BOUT
SW3
M2
M2
PROG
<1''
SW3