Initial Programming With One Entry Panel; Initial Programming With Multiple Entry Panels - CAME PLACO-VC 001CS2PLC0 Programmierhandbuch

Initial programming with ONE entry panel

VA/01
PROG PROG
A
>3''
³
M1
BOUT
·
M1
BOUT
¿
beep
´
beep
²
VA/01
PROG PROG
A
<1''
EN
¾

Initial programming with MULTIPLE entry panels

VA/01
PROG PROG
A
>3''
³
1 P.E
PROG
M1 M1
SW3
BOUT BOUT
·
M2
8
Accessing programming
Press the PROG button on the power supplier until the PROG LED comes on. If the PROG LED does
not come on, this shows a fault. Check the connections and go back to programming.
The PROG LED and the backlighting of the buttons will fl ash as shown in fi gure .
M1
Wait 5 seconds for the self-test to be completed and then continue as described below.
PROG
M1
SW3
BOUT
»
M2
Programming button type
Press the fi rst button on the entry panel in the position marked / A B until the backlit LEDS stop
fl ashing and remain lit.
An acoustic signal will notify entrance in "Call button programming".
PROG
beep
SW3
M2
Call button programming
Release by pressing the button
button
associate with the internal extensions : a beep will show that it has been memorised.
Press the PROG button
¶
Exiting programming
Briefl y press the PROG button: the PROG LED goes off and the entry panel stops ringing.
N.B. If no action is performed, the procedure will automatically end after 30 minutes.
M1
Accessing programming
Press the PROG button on the power supplier until the PROG LED comes on.
If the PROG LED turns off suddenly, this indicates a malfunction in the connection between the power
supplier and the entry panel. Check the connections and go back to programming.
M1
The PROG LED and the backlighting of the buttons will fl ash as shown in fi gure . Wait 5 seconds for
the self-test to be completed and then continue as described below.
2 P.E 3 P.E
PROG
PROG
M1
SW3
SW3
BOUT
M2 M2
PROG
M1
SW3
BOUT
» A
M2
on the panel to be programmed
and the AUX2 button at the same time. On the entry panel, press the call button to
and continue, repeating the same operations for all the other extensions.
beep
beep
PROG
M1
SW3
BOUT
» B
M2
and press the door release
º
PROG
SW3
M2