Reprogramming Procedure - CAME PLACO-VC 001CS2PLC0 Programmierhandbuch

1 P.E 2 P.E
PROG PROG
M1
M1 M1
SW3 SW3
BOUT
BOUT BOUT
»
M2
M2
1 P.E 2 P.E
PROG
PROG
M1 M1
M1
SW3
SW3
BOUT
BOUT BOUT
¿
M2 M2
beep
¶
beep
º
VA/01
PROG PROG
A
<1''
¸

Reprogramming procedure

VA/01
PROG PROG
A
>3''
³
1 P.E 2 P.E
beep
PROG PROG
M1
M1
M1
SW3 SW3
BOUT
BOUT BOUT
·
M2 M2
Programming button type
3 P.E
Press the fi rst button on the entry panel until the backlit LEDS stop fl ashing . Repeat the operation
on all entry panels to be reprogrammed : once complete, the signals will in confi guration .
An acoustic signal will notify entrance in "Call button programming".
PROG
SW3
M2
1 P.E
3 P.E
PROG
PROG
M1 M1
SW3 SW3
BOUT
BOUT
´
M2 M2
Call button programming
Release by pressing the button
button e and the AUX2 button at the same time. On the entry panel, press the call button to
associate with the internal extensions : a beep will show that it has been memorised. Press the PROG
button and continue, repeating the same operations for all the other extensions. This operation
can only be performed from the entry panel with acoustic signalling active (PE1 in fi g. ): to change
the entry panel from which the call programming is performed, press one call button for at least 3s.
beep
¾
Exiting programming
Briefl y press the PROG button: the PROG LED goes off and the entry panel stops ringing.
N.B. If no action is performed, the procedure will automatically end after 30 minutes.
M1
Accessing programming
Press the PROG button on the power supplier until the PROG LED comes on. The PROG LED and the
backlighting of the buttons will fl ash as shown in fi gure . Wait 5 seconds for the self-test to be com-
M1 pleted and then continue as described below.
3 P.E
PROG
SW3
M2
2 P.E 3 P.E
beep
PROG
PROG
M1
M1
SW3
SW3
BOUT
BOUT
²
M2
M2
on the panel to be programmed
beep
1 P.E 2 P.E 3 P.E
PROG PROG
M1
M1
SW3
SW3
BOUT
BOUT
M2
M2
and press the door release
µ
PROG
SW3
M2
EN
9