Reprogramming Procedure - CAME PLACO-VC 001CS2PLC0 Programmierhandbuch

´
²
PROG
M2
M1
BOUT
M2
M1
SW3
¾
BOUT

Reprogramming procedure

PROG
M2
M1
BOUT
M2
M1
SW3
BOUT
³
PROG
M2
M1
M1
BOUT
SW3
BOUT
·
M2
¿
beep
´
PROG
M2
M1
BOUT M2
M1
SW3
¶
BOUT
Call button programming
Release by pressing the button
ton e and the AUX2 button at the same time.
On the entry panel, press the call button to associate with the internal extensions : a beep will show
that it has been memorised.
Press the PROG button
¶
Exiting programming
PROG
Briefl y press the PROG button: the PROG LED goes off .
<1''
N.B. If no action is performed, the procedure will automatically end after 30 minutes.
SW3
Accessing programming
Press the PROG button for at least 3 seconds and release it (within 6 seconds) as soon as the PROG
PROG
>3''
LED fl ashes and the backlighting on the buttons comes on as shown in fi gure .
<6''
If the PROG LED does not come on, this shows a fault. Check the connections and go back to program-
ming.
SW3
PROG
SW3
»
Call button programming
Release by pressing the button
ton e and the AUX2 button at the same time.
On the entry panel, press the call button to associate with the internal extensions : a beep will show
that it has been memorised.
Press the PROG button
Exiting programming
PROG
Briefl y press the PROG button: the PROG LED goes off .
<1''
N.B. If no action is performed, the procedure will automatically end after 30 minutes.
SW3
on the panel to be programmed and press the door release but-
and continue, repeating the same operations for all the other extensions.
beep
on the panel to be programmed and press the door release but-
and continue, repeating the same operations for all the other extensions.
²
º
5
EN