C) Flight Movements; D) Trimming - Reely Blackster R7 FPV Bedienungsanleitung

c) Flight movements

After the model has been started, it is in hover flight. The model will try to maintain altitude in this. Push the left control
lever at the transmitter forward carefully. This initiates rising of the model. Put the left control lever into the neutral
position again to stop rising. Pull the left control lever back carefully to start sinking.
If you move the left control lever to the left, the model will turn around its vertical axis. If you move it towards the right,
the quadrocopter will turn to the right.
Push the right control lever forward carefully. The model is controlled forward. If you push the right control lever
backwards, the quadrocopter will be controlled backwards.
If the right control lever is controlled to the left, the model will float to the left. If you move the right control lever to the
right, the quadrocopter will float to the right.
When controlling the model, also observe the notes in chapter 11.

d) Trimming

In the course of flight operation, it is possible the quadrocopter will not hover in place but drift off in one direction
(e.g. forward). In this case, the model must be returned to the condition where the quadrocopter hovers in place by
trimming.
To trim the model, push the button "Trimming" (figure 13; also see figure 3, item 6). The control LED at the transmitter
flashes. Now push the respective control lever for the drift direction (e.g. the quadrocopter drifts forward = right control
lever for the control function nod) into the opposite direction. In this example (quadrocopter drifts forward), pull the
right control lever backwards. The rear LEDs of the quadrocopter flash when you perform this trimming. Hold or push
the control lever as long/as often as necessary to achieve a stable flight condition. Now push the button for the trim
again to leave trimming mode.
Attention!
When trimming mode is activated, you cannot control the model with the two control levers. Therefore, only
perform trimming when you have enough space and a sufficient flight altitude. When not observing this,
there is a danger of damage to the model or other objects nearby and a danger of injury to persons/animals
in the vicinity from contact or crash!
Figure 13
53