Ingersoll-Rand 5020-EU Serie Bedienungsanleitung Seite 2

FAILURE TO OBSERVE THE FOLLOWING WARNINGS COULD RESULT IN INJURY.
WARNING
Always wear eye protection
when operating or perform-
ing maintenance on this
tool.
WARNING
Air powered tools can vibrate
in use. Vibration, repetitive
motions or uncomfortable po-
sitions may be harmful to your
hands and arms. Stop using
any tool if discomfort, tingling
feeling or pain occurs. Seek
medical advice before resum-
ing use.
WARNING
Keep body stance balanced
and firm. Do not overreach
when operating this tool.
LUBRICATION
Ingersoll–Rand No. 50
Always use an air line lubricator with these tools.
We recommend the following Filter–Lubricator– Regulator
Unit:
International: No. C18–C3–FKG0
After each eight hours of operation, unless an air line
lubricator is used, remove the Oil Chamber Plug and fill the
oil chamber with Ingersoll–Rand No. 50 Oil.
After each eight hours of operation, inject about 1.5 cc of
Ingersoll–Rand No. 100 Grease through the Grease Fitting to
lubricate the impact mechanism.
After each forty–eight hours of operation, or as experience
indicates, remove the Hammer Case and check the lubrication
of the impact unit and gearing. Using Ingersoll–Rand No. 100
Grease, coat only the jaws of the Hammer and the jaws of the
Anvil. Apply a thin film of No. 100 Grease to the pilot of the
Torsion Bar or the Planet Gear Frame Pilot and place a small
amount in the cam grooves at the jaw end of the Hammer and
on the Hammer Spring Thrust Bearing Balls. Lubricate the
gearing with Ingersoll–Rand No. 28 Grease. Use grease
sparingly. Excessive lubrication will retard the action of the
tool.
WARNING LABEL IDENTIFICATION
Always wear hearing
protection when operating
this tool.
Do not carry the tool by
the hose.
90 psig
Operate at 90 psig (6.2 bar/
(6.2bar/620kPa)
620 kPa) Maximum air pressure.
PLACING TOOL IN SERVICE
Ingersoll–Rand No. 100
Ingersoll–Rand No. 28
WARNING
WARNING
WARNING
MAIN LINES 3 TIMES
AIR TOOL INLET SIZE
TO
AIR
SYSTEM
TO
AIR
TOOL
LUBRICATOR
REGULATOR
BRANCH LINE 2 TIMES
AIR TOOL INLET SIZE
DRAIN REGULARLY
OILER ADJUSTMENT
If the built–in lubricator fails to provide proper lubrication to
the tool, it can be adjusted by removing the Oil Chamber Plug
from the Motor Housing and inserting a small screwdriver
through the opening in the Housing to turn the Oiler Adjusting
Screw. Rotate the Screw clockwise to decrease the oil flow
and counterclockwise to increase the flow. If the lubricator
cannot be adjusted to provide an acceptable oil flow, replace
the Oiler Felt.
2
WARNING
Always turn off the air sup-
ply and disconnect the air
supply hose before install-
ing, removing or adjusting
any accessory on this tool,
or before performing any
maintenance on this tool.
WARNING
Do not use damaged, frayed
or deteriorated air hoses
and fittings.
International Warning Label:
Order Part No. ___________
FILTER
COMPRESSOR
(Dwg. TPD905–1)