Water Tank & Drain Hose - INVENTOR PR1-30XL Bedienungsanleitung

7. Water tanK & Drain hOse
There are two ways to remove collected water. Before proceeding ensure that you have
switched off and unplugged the unit.
1. Usage of the water
When unit is OFF and the tank of the dehumidifier is full, the full indicator will be lit,
and the display will read P2. Additionally, when the unit is on and the tank is full, the
compressor stops operation followed by the fan a few minutes later. The full indicator
will flash and the display will show P2.
• Slowly remove the bucket. Grip the handle with caution, and carefully pull outwards so
the water does not overflow. Do not place the tank on the floor because the bottom of
the tank is uneven. Doing so the tank will fall and the water will be spilled on the floor.
• Empty the water from the tank and place it again in to the device. The water tank, must
be securely and properly placed, for the dehumidifier to operate.
• When the water tank is re-installed the unit will automatically restart.
• When you remove the tank, do not touch any parts
• Be sure to gently place the tank into the dehumidifier.
• Do not drink or use the collected water from the
• Wipe any excess water on, or in, the unit when
2. Continuous draining
Water automatically can be emptied into a floor drain by
attaching the unit with a water hose.
• Remove the rubber plug located opposite the unit.
Insert the water hose into the drain outlet and make
sure all connections are firmly tightened in order to
avoid any possible leaks.
• The dehumidifier should be placed on a flat surface in
an upright position.
• Lead the water hose towards a suitable drainage
facility and be certain that the water flows naturally.
For correct drainage, make sure the hose stays below
the level of the drain hose outlet.
12
inside the unit, as you may damage the device.
device.
removing the tank.
water drain hose
outlet
EN