Water Tank & Drain Hose - INVENTOR P3F-50LBS Bedienungsanleitung

7. WATER TANK & DRAIN HOSE
There are three ways to remove collected water. Before proceeding ensure that you have
switched off and unplugged the unit.
1. Usage of the water tank
When unit is OFF and the tank of the dehumidifier is full, the full indicator will be lit and the
display will read P2. Additionally, when the unit is on and the tank is full, the compressor stops
operation followed by the fan a few minutes later. The full indicator will flash and the display
will show P2.
• Slowly remove the bucket. Grip the handle with caution and carefully pull outwards so
the water does not overflow. Do not place the tank on the floor because the bottom of the
tank is uneven. Doing so the tank will fall and the water will be spilled on the floor.
• Empty the water from the tank and place it again in to the device. The water tank, must be
securely and properly placed, for the dehumidifier to operate.
• When the water tank is re-installed the unit will automatically restart.
• When you remove the tank, do not touch any parts inside the unit, as you may damage the
device.
• Be sure to gently place the tank into the dehumidifier.
• Do not drink or use the collected water from the device.
• Wipe any excess water on or in the unit when removing the tank.
12
• When bucket is removed if the pump hose disconnects,
before replacing the bucket the pump hose must be
reconnected
• If the bucket is removed during operation, the
compressor and the fan turns off, the unit will beep and Eb
will appear on the digital display.
• If the bucket is removed when unit is Off, the unit will
beep and Eb will appear on the digital display.
Reinstall pump
hose properly
Pump hose
drops
EN