Auto Defrost - INVENTOR PR1-30XL Bedienungsanleitung

fan
Press the FAN button to select between the Low and High fan speed.
•Low Fan Speed: Press the Fan button to select LOW fan speed mode, when
the humidity has been reduced and quite operation is preferred, to enjoy ideal
conditions. The low fan speed indicator ( ) will flash.
•High Fan Speed: Press the Fan button to select HIGH fan speed mode, when
immediate dehumidification is necessary, such as areas or rooms that are
unused for an extended period of time. The high fan speed indicator (
will flash.
sWing
Press the SWING button to activate the swing feature.
• Use this setting in order to avoid direct air flow thus ensuring a more wide
air flow angle from 45 to 90 degrees.
• By pressing this button for 3 seconds you may set the lock/unlock function
of the control panel, to prevent minors from tampering with the unit. The lock
feature indicator ( ) will light up.
timer
Use this button to set the unit off function, by intervals of 1 to 8 hours. The unit will turn
off when the desired setting is applied.
inDiCatiOns
Bucket Full Indicator
When the water tank is full, removed or misplaced the alarm will beep. The indicator on
the control panel will turn on and the device will automatically stop operating. The water
tank must be removed, emptied and reinstalled before the unit continues to operate.

Auto Defrost

When frost builds up on the evaporator coils, the compressor will cycle off and the fan
will continue to run until the frost disappears.
• This function not only ensures the safe and appropriate operation of the
dehumidifier but is also more efficient and economical in its performance.
EN
When operating under SHOES & CLOTHES modes
the Fan speed is automatically set to High. This
cannot be set manually.
)
11