Heyner SuperProtect ERGO Bedienungsanleitung Seite 7

English
Index / pages
1. Using the HEYNER®Baby SuperProtect ERGO as a child's car seat
2. Adjusting the HEYNER®Baby SuperProtect ERGO to your baby's size
3. Installing the HEYNER®Baby SuperProtect ERGO car seat into your car
4. Carrying Handle Positions
5. Using the HEYNER®Baby SuperProtect ERGO with a stroller
6. Care Instructions
7. Important Notices
Operating Instructions
A Seat shell
B Side belt guide
C Rear belt guide
D Carrying handle unlock button
E Harness belts / shoulder belts
F Belt buckle
G Carrying handle
11
H Shoulder belt slots
I Belt adjuster
J Belt end element
N Diagonal belt
O Lap belt
P Belt latch
Q Belt buckle
1. Using the HEYNER®Baby SuperProtect ERGO as a child's car seat
S. 11
You have purchased the HEYNER®Baby SuperProtect ERGO car seat for your child. We thank
S. 11
you for your trust. Please note, that the optimum safety characteristics can only be achie-
ved, if the seat is used properly according to instructions. Therefore we ask you to
S. 13
ensure the correct installation of the seat in your vehicle by reading the operating
S. 15
instructions carefully. Please keep instructions always with the seat for further information.
S. 16
S. 16 Only to be assembled by adults!
S. 17
2. Adjusting the HEYNER®Baby SuperProtect ERGO
to your baby's size
Fig. 1
The baby seat HEYNER®Baby SuperProtect ERGO has its own belt system (E), a harness
system, which needs to be adjusted to your baby's size as follows: Place the HEYNER®Baby
SuperProtect ERGO on a normal chair or on the floor and lay your baby inside. To ensure an
optimal positioning of the belts, make sure that the harness belts (E) run down from short
above the child's shoulders (fig. 1c), not too high above them (fig. 1a) and not too low (fig. 1b).
Attention: Never leave your baby unattended in the non-fixed baby seat!
English
GB
12