Setting The Speed Level; Barrel Roll; Calibration - lidl QC 360 A1 Bedienungsanleitung

Setting the speed level

The quadrocopter has two speed settings you can use depending on your flight
experience level.
♦ Set the speed selector switch
setting is recommended for pilots who have little or no flight experience.
♦ Set the speed selector switch
is recommended for pilots who already have experience with flying quadrocopter
models.

Barrel roll

Once you have acquired a bit of experience with the quadrocopter, you can
attempt a barrel roll.
♦ Fly the quadrocopter up to a height of about 2–3 metres and keep it hovering.
♦ Press the control lever
beep to signal that the quadrocopter is in barrel roll mode.
♦ Move the control lever
The quadrocopter will then do a barrel role in the corresponding direction.

Calibration

If the quadrocopter shows a tendency to move off in one direction (drift), you will
need to calibrate it.
♦ Place the quadrocopter on a dry and level horizontal surface.
♦ Pull the throttle lever
right corner at the same time. The quadrocopter's control lamps
3 seconds. As soon as the control lamps
complete and the quadrocopter is ready to fly again.
■ 12 │ GB │ IE
to the position "–" for a slower speed. This speed
to the position "+" for a higher speed. This speed
downwards. The remote control emits a continuous
in one direction (forwards/backwards/right/left).
to the lower left corner and the control lever
light up permanently, calibration is
to the lower
will flash for
QC 360 A1