Setting The Speed (Fig. M) - lidl 311499 Gebrauchsanweisung

• Hover left/right (roll) (Fig. L)
If you want to perform a movement to the right
or left without rotating the quadrocopter (1), i.e.
hover sideways, move the right control lever (2l)
to the left or right.
• Turning (yaw trimming) (Fig. O)
If the quadrocopter (1) moves around its own
axis of its own accord without you moving the
steering lever (2l), you can correct this with the
yaw-trimming.
If the quadcopter (1) is turning clockwise, press
the yaw-trim lever to the left (2f), and if it is
turning anti-clockwise, press the roll-trim lever to
the right (2d). In this way you counter the yaw
movement by trimming in the opposite direction.
• Direction (roll and pitch trimming) (Fig. P)
If there is a forwards or backwards movement
even though you are not using the control lever
(2l) at all, you can correct this by pitch trim-
ming. If the quadrocopter (1) is flying forwards,
press the pitch-trimming button (2o) and vice
versa (2m). You can counteract the unwanted
movement with the trim setting.
If the quadrocopter (1) moves sideways of
its own accord, you can correct this by roll
trimming.
If the quadrocopter hovers to the left (1)
sideways, press the trimming button (2n) to the
right and vice versa (2p). This allows you to
counteract the unwanted movement.
• Headless mode (Fig. Q)
This refers to a flight aid that when activated
enables the quadrocopter (1) to always fly in
the direction it is steered. It is recommended for
pilots with little flying experience.
When headless mode is activated using button
(2c), from the pilot's viewpoint, the quadrocop-
ter (1) always flies to the right when the control
lever (2l) is steered to the right, regardless of
which way the front of the quadrocopter (1) is
facing.
NOTE: The direction of the remote control
(2) and the quadrocopter (1) must corre-
spond exactly when headless mode is activated!
Only activate headless mode in the position spec-
ified, otherwise it may result in control commands
not being carried out correctly.
56 GB/MT
1. To activate headless mode, put the quadrocop-
ter (1) and the remote control (2) one behind
the other and press the button (2c) on the
remote control (2).
The display (2j) message HEADLESS lights up
and the quadrocopter lights flash slowly as long
as the mode is activated.
2. To deactivate the mode, press the button
(2c) again. On the display (2j), NORMAL is
illuminated and the quadrocopter lights light up
continuously again.
• Automatic return to the pilot (Fig. R)
Press the active button (2c) for approx. 3
seconds if the quadrocopter is to return via the
same route flown.
NOTE: Note that the return route can vary
as a result of the quadrocopter turning. The
operation can be cancelled by pressing the button
(2c) repeatedly or by moving the control lever
(2l).

Setting the speed (Fig. M)

You can adjust the flight speed by repeatedly
pressing the relevant buttons (2e, 2g) on the
remote control (2). The default setting is speed 2,
from a total of four speed levels.
The display lights show the various levels (2j).
Speed 1
(one beep)
For first attempts with little flight experience.
Speed 2
(two beeps)
For pilots with some experience.
Speed 3
(three beeps)
For experienced pilots.
Speed 4
(four beeps)
For very experienced pilots.
NOTE: When the remote control is turned
off and on, the quadrocopter (1) is reset to
speed 2.