Functional Description; M-Drive; Putting Into Operation; Risk Of Injury - Abicor Binzel MFS-V2 Betriebsanleitung

MFS-V2

5 Functional Description

The wire feeding systems consists of MFS-V2 E-Box and M-Drive. The following components are included
in the master feeder system MF:
1 MF 1/2
2 Cable assembly with control
lead M-Drive - MF 1/2
3 MFS-V2
Fig. 5 Configuration of the master feeder system MF
All elements are combined to form a functional unit.
5.1 E-Box
All electronic components are installed in the metal housing. The power supply is provided via a separate
connecting cable. For the connection voltage and power consumption, see
 3.1 Technical Data on page EN-5

5.2 M-Drive

The M-Drive is adapted electronically and mechanically to the master feeder system. All required valves and
connections have been installed in the housing.

6 Putting into operation

Risk of injury due to unexpected start-up.
The following instructions must be adhered to for the entire duration of maintenance, servicing, mounting,
dismounting and repair work:
• Switch off the power supply.
• Disconnect the compressed air supply.
• Pull the mains plug.

Risk of injury

Safety switches on covers and protective devices are ineffective in manual mode.
• High concentration.
1 2 3
A
11
D
C
10 9
4 Control lead M-Drive - E-Box
5 Options
6 Control lead
process power supply - E-Box
DANGER
DANGER
4 5
M-Drive
B
E-Box
6
E
F
8 7
7 Control lead
process power supply - M-Drive
8 Process power supply
9 Control lead robot control - E-Box
5 Functional Description
10 Robot control
11 Control lead
robot control - robot
EN - 9