Controls Swap Button - Boston Scientific Lithovue System Bedienungsanleitung

When there are zero minutes remaining, the time remaining Indicator will disappear and the "Use
time Exceeded" message screen will appear in the image display. See Section 4.3 "Message Screens"
for more information on the use time exceeded message screen.
If additional time is needed for the procedure, after the "Use Time Exceeded" message displays, a new
LithoVue™ Flexscope will need to be used.
table 4�1 Symbols indicating operating time remaining on the LithoVue Flexscope
color/State of Icon Green Icon
Icon
with case,
User response

controls Swap Button

Pressing the Controls Swap button moves the control buttons and indicators to the opposite side of the
screen for user convenience (see Figures 4.6a and 4.6b). At the next system startup, the system will
default to displaying control buttons and indicators on whichever side was last selected by the user.
Default Controls Swap Button
After pressing the Controls Swap button, the button will briefly illuminate to acknowledge the button
press before returning to the default state.
Controls Swap Button after a button press
Figure 4�6a – Main operating Screen – controls on Left
User's Manual
Yellow Icon
Proceed Proceed
with case,
no action no action
required required
Orange Icon Orange Icon Blinking
30 minutes of scope
Proceed with
use remaining.
case, being
Obtain another scope
cautious of
if additional time
time remaining
is needed.
29
Black (K) ∆E ≤5.0