Safety Instructions For Led Lights; Safety Instructions For Batteries; Original Accessories / Tools; Start­up - Parkside PFBS 160 A1 Originalbetriebsanleitung

General power tool safety warnings / Start-up
piece. Use clamps or a vice to grip the workpiece
firmly. This is much safer than holding it in your
hand.
support yourself by placing your hands near or
in front of the device or the workpiece surface.
A slip can result in injury.
DANGER OF FIRE FROM FLYING SPARKS!
Abrading metal creates flying sparks. For this
reason, always make sure that nobody is placed
in any danger and that there are no inflammable
materials near the working area.
harmful / noxious dusts generated from machin-
ing represent a risk to the health of the person
operating the device and to anyone near the
work area.
Wear a dust mask!
there is adequate ventilation when machining
surfaces containing plastic or covered with
paint, varnish etc.
Its use as a saw or the use of saw blades with
this device is prohibited.
Do not soak the materials or the surface you are
about to work on with liquids containing solvents.
Avoid abrading paints containing lead or other
substances hazardous to health.
Do not machine materials containing asbestos.
Asbestos is a known carcinogen.
Avoid contact with moving sanding or grinding tools.
Do not machine moist materials or damp surfaces.
NOTE! Do not allow the tool to come to a
standstill by overloading it!
Switch the device off and allow it to come to a
standstill before you put it down.
clean, dry and free of oil or grease.
Children or persons who lack the knowledge or
experience to use the device or whose physical,
sensory or intellectual capacities are limited must
never be allowed to use the device without super-
vision or instruction by a person responsible for
their safety. Children must never be allowed to
play with the device.
44 GB/MT
Securely support the work-
RISK OF INJURY! Never
DUST HAZARD! Any
TOXIC DUST! Ensure that
RISK OF INJURY!
Always keep the device

Safety instructions for LED lights

ATTENTION! RISK OF EYE INJURY! Never
aim the light beam directly at people or animals,
and never look directly into the light beam of
LED lights.

Safety Instructions for batteries

ATTENTION!
Do not leave drained battery in the device, as
even leak-proof batteries can corrode, releasing
chemicals which could be harmful to your health
or ruin the device.
Do not leave batteries lying about carelessly.
Children or pets could swallow them. If acciden-
tally swallowed seek immediate medical attention.
Remove the batteries from the device when it
will not be used for extended periods to prevent
leaks.
Touching leaked or damaged batteries may
cause chemical burns. Therefore wear suitable
protective gloves in this event.
Ensure batteries are not short-circuited. Never
throw batteries into fire.
Do not recharge batteries. Explosion hazard!

Original accessories / tools

Use only the accessories and attachments de-
tailed in the operating instructions, or those which
are compatible with the tool.
Start­up
Attaching / changing the
tool / collet
Press and hold the spindle lock
Turn the clamping nut
6
Loosen the clamping nut
nation wrench for the thread.
25
If applicable, remove the attached tool.
.
9
until the lock catches.
using the combi-
6